Volt VAL-1813-40-BBZ Installation Instructions Manual

INSTALLATION INSTRUCTIONS

VOLT® Low Voltage Landscape Lighting

®

VOLT

VAL-1813-40-BBZ

Woodsman Single Source LED Downlight

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

Specications and product details subject to change without notice.

© Copyright 2019, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.

[e-mail] • 813.978.3700

- 1 -

INSTALLATION INSTRUCTIONS

VOLT® Woodsman Single Source LED Downlight
VAL-1813-40-BBZ

Important: Please Read Before Installation

!

This xture is intended for installation in accordance with local codes and
the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.

Package Contents

A. (1) Fixture

Product Dimensions

6 5/8”

These instructions do not intend to cover all variations in installation,

operation maintenance or mounting situations.

1. Make sure that the power is turned OFF before installing or servicing
this xture.

2. Warning: this xture is not intended to be installed within 10 feet [3
meters] of a pool, spa or fountain.

3. This xture is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 12 volts.

4. Underground Low Energy Cable must not be buried over 6” (15.2 cm)
in order to connect to the main low voltage cable.

5. Wiring connections must be made with wire connectors that are
suitable for outdoor use.

6. Position the wire connector so that it is located within 6 inches (15.2
cm) from a building structure, a luminaire, or tting.

Important Safety Instructions

!

LIGHTED LAMP IS HOT!

WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.

1. Turn off/unplug and allow to cool before reducing lamp.

2. Lamp gets HOT quickly!

3. Do not touch the hot lens, guard or cowl.

4. Keep lamp away from materials that may burn.

5. Do not touch lamp at any time.

6. Use a soft cloth.

7. Oil from skin may damage lamp.

8. Do not operate the xture with a damaged or missing lens or shield.

4.68”

Install Fixture

1

Foot

Spacer

Anchor (optional,
not supplied)

Washer (not supplied)

Self-tapping Screw

(not supplied)

Fixture

4 1/8”

Determine the desired location

for the xture. Place the washers
onto the self-tapping screws. Pass
the self-tapping screws through
the holes of the feet of xture and
spacers. Thread the self-tapping

screws into the desired location to

secure the xture.

NOTE: Anchors are required for
brick walls or concrete walls. To
determine the locations for the
anchors place the feet of the xture

onto your desired location and mark

points from the holes of the feet.

www.voltlighting.com

- 2 - - 3 -

[e-mail] • 813.978.3700