Volt VAL-1810-40-BBZ Installation Instructions Manual

INSTALLATION INSTRUCTIONS

VOLT® Low Voltage Landscape Lighting

VOLT® Top Dog Downlight Cast Brass

VAL-1810-40-BBZ

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

Specications and product details subject to change without notice.

© Copyright 2019, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.

[e-mail] • 813.978.3700

INSTALLATION INSTRUCTIONS

VOLT® Top Dog Downlight Cast Brass
VAL-1810-40-BBZ

Package Contents

A. (1) Fixture

B. Oset kit with self-tapping screws

Important: Please Read Before Installation

!

This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.

These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.

1. Make sure that the power is turned OFF before installing or servicing this
luminaire.

2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or
more from pool, spa or fountain.

3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.

4. Wiring connections must be made with wire connectors that are suitable
for outdoor use.

5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or tting.

6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm).

7. If additional lengths of low voltage cable are required, please contact
www.voltlighting.com or call 1-813-978-3700.

Parts Required (sold separately)

A. (1) MR16 Lamp

Product Dimensions

5.8”

2.5”

2.3”

Important Safety Instructions

!

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS

Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

1. Turn o/unplug and allow to cool before replacing lamp.

2. Lamp gets HOT quickly! Contact only switch/plug when turning on.

3. Do not touch the hot lens, guard or enclosure.

4. Keep lamp away from materials that may burn.

5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.

6. Do not operate the luminaire tting with a missing or damaged shield.

SAVE THESE INSTRUCTIONS

www.voltlighting.com

Remove Shield and Glare Guard

1

Fixture

Shield

Screw

[e-mail] • 813.978.3700

Use a screwdriver to unlock the
screw and remove the glare guard
from the shield. Then, remove the
shield from the xture.

Glare Guard