Volt Stratum 9 inch, Stratum 12 inch, 310 Series Installation Instructions Manual

VOLT® Low Voltage Landscape Lighting

VOLT® Stratum 9” & 12” Path & Area Light

VPL-300 Series

INSTALLATION INSTRUCTIONS

Specications and product details subject to change without notice.

© Copyright 2017, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.

[e-mail] • 813.978.3700

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

VOLT® Stratum 9” & 12” Path & Area Light
VPL-300 Series

Important: Please Read Before Installation

IMPORTANT SAFETY INSTRUCTIONS

INSTALLATION INSTRUCTIONS

This luminaire is intended for installation in accordance with local codes

and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.

These instructions do not intend to cover all variations in installation,

operation maintenance or mounting situation.

1. Make sure that the power is turned OFF before installing or servicing this
luminaire.

2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or
more from pool, spa or fountain.

3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.

4. Wiring connections must be made with wire connectors that is suitable for
outdoor use.

5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or tting.

6. The main low voltage cable is intended for shallow burial - less than 6

inches (152 mm)

7. If additional lengths of low voltage cable is required, please contact www.
voltlighting.com or call 1-813-978-3700.

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS

Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

1. Turn off/unplug and allow to cool before replacing lamp.

2. Lamp gets HOT quickly! Contact only switch/plug when turning on.

3. Do not touch the hot lens, guard or enclosure.

4. Keep lamp away from materials that may burn.

5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.

6. Do not operate the luminaire tting with a missing or damage shield.

SAVE THESE INSTRUCTIONS

!

!

www.voltlighting.com

[e-mail] • 813.978.3700

Package Contents

A. (1) Finial

B. (1) Waterproof Washer

C. (1) Shade

D. (1) Inner Shield

E. (1) Harp

F. (1) Stake

G. (1) Rod with Socket

Product Dimensions

Install Stake

1

Determine the desired location for mounting

the luminaire. Hammer the stake into the
ground until ange of stake is ush to grade.
To avoid damage to the stake, place a board on
top of the stake while hammering.

NOTE: If the ground is hard and the stake

is difcult to install, make a crosscut in the
ground using a at shovel.

Board

Stake

Soil

Ground