Volt All-Star Brass Tommy Light Installation Instructions Manual

INSTALLATION INSTRUCTIONS

VOLT® Low Voltage Landscape Lighting

LED All Star Tommy Light

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

Specications and product details subject to change without notice.

© Copyright 2017, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.

[e-mail] • 813.978.3700

INSTALLATION INSTRUCTIONS

VOLT® LED All Star Tommy Light

Package Contents

A. (1) Fixture

Important: Please Read Before Installation

!

This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes
and instructions may result in serious injury, property damage, or void the
warranty.

These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situation.

1. Make sure that the power is turned OFF before installing or servicing
this luminaire.

2. WARNING: risk of electrical shock. Install all luminaires 10 feet
(3.05M) or more from pool, spa or fountain.

3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.

4. Wiring connections must be made with wire connectors that is suitable
for outdoor use.

5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or
tting.

6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm)

7. If additional lengths of low voltage cable is required, please contact
www.voltlighting.com or call 1-813-978-3700.

Parts Required (Sold Separately)

A. (3) Self-tapping Screws

B. (3) Wall Anchors

Product Dimensions

2.55”

Remove Faceplate and Glare Guard

1

C. (1) LED MR16 Lamp

3.10”

5.00”

Important Safety Instructions

!

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS

Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

1. Turn off/unplug and allow to cool before replacing lamp.

2. Lamp gets HOT quickly! Contact only switch/plug when turning on.

3. Do not touch the hot lens, guard or enclosure.

4. Keep lamp away from materials that may burn.

5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.

6. Do not operate the luminaire tting with a missing or damage shield.

SAVE THESE INSTRUCTIONS

www.voltlighting.com

Use a screwdriver to unlock the set
screw. Then, remove the glare guard

Fixture

from the faceplate. Next, remove the
faceplate from the xture.

Faceplate

Screw

Glare Guard

[e-mail] • 813.978.3700