vollara safe hearth User Manual
SAFE
HEARTH
PORTABLE HEATING SYSTEM
WITH ACTIVEPUR E T ECH N OLO GY
• Installation
• Operation
• Specifications
• Warranty
®
USER’S MANUAL
65-00382 EA-03296
CAUTION: Read manual carefully for
proper procedures and operation.
3
INTRODUCTION
Congratulations, your new SafeHearth™ is designed to
provide years of trouble-free, low maintenance operation.
Be sure to read and follow all service procedures outlined
in this owner’s manual, and use only genuine Vollara
replacement parts available from your Vollara
Distributor.
If you have any questions concerning this, or any Vollara
product, contact your Vollara
Distributor.
Please record the name and phone number of your
Vollara Distributor:
Name _______________________________________
Phone _______________________________________
Please record the serial number of your
SafeHearth™:
Serial # _____________________________________
Electrical:
• Voltage: 120V~ 60Hz
• Power consumption: 1000–1500 Watts.
• Heat output: rated at 5,100 BTU
• Automatic shut-off: heat can be set to automatically
shut off. 2,4,6 or 8 hours
• Expected lifecycle: over 28000 hours
• Air purification: ActivePure Technology
Coverage:
• Coverage: Up to 1000ft
2*
Size:
• Dimensions: 16
4
/5" high x 13" wide x 16 3/5" deep
• Weight: 22 pounds
Warranty
• 3 year limited Warranty.
Safety Protection:
• Overheat safety feature
• Tip-over safety feature
• Auto-lock feature
Other Features:
• Washable filter
• Remote control
When not in use, unit should be stored in a clean/dry
environment (60 - 80º F (15 - 27º C)) and 50 - 60% RH.
SPECIFICATIONS
IMPORTANT INSTRUCTIONS
WARNING! - WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
TO REDUCE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PERSONS, INCLUDING THE FOLLOWING:
• CAUTION: Risk of Electric Shock. DO NOT open or try
to repair the heater yourself.
• This heater may get hot when in use. To avoid burns,
DO NOT let bare skin touch hot surfaces. Use caution
when moving this heater.
• Keep combustible materials, such as furniture, pillows,
bedding, paper, clothes, and curtains at least 3 ft from
the front of the heater and keep them away from the
sides, top, and rear. DO NOT place towels or other
objects on the heater.
• Extreme caution is necessary when any heater is used
by or near children or the disabled, or when the heater
is left operating and unattended.
• DO NOT operate any heater with a damaged cord or
after the heater malfunctions, has been dropped or
damaged in any manner. Return heater to authorized
service facility for examination, electrical or mechanical
adjustment, or repair.
• This heater is not intended for use in bathrooms,
laundry areas and similar indoor locations. NEVER
locate heater where it may fall into a bathtub or other
water container. To protect against electrical hazards,
DO NOT immerse in water or other liquids.
• DO NOT touch the control panel or plug with a wet hand.
• DO NOT run cord under carpeting. DO NOT cover cord
with throw rugs, runners, or similar coverings. Arrange
cord away from traffic area and where it will not be
tripped over.
• DO NOT insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
• To prevent a possible fire, DO NOT block the air intakes
or exhaust in any manner. DO NOT use on soft surfaces,
like a bed, where openings may become blocked.
• The heater has hot parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are used or stored.
• Always plug heaters directly into a wall outlet/
receptacle. Never use with an extension cord or
relocatable power tap (outlet/power strip).
• Never operate heater without filter in place
• To avoid fire or shock hazard, plug the unit directly into
a 120 V AC electrical outlet.
• To disconnect heater, turn controls to OFF, then remove
plug from outlet. Pull firmly on the plug, DO NOT unplug
by pulling on the cord.
• Always unplug the unit before moving or cleaning, or
whenever the heater is not in use.
• Use only for intended household use as described in
this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury
to persons. The use of attachments not recommended
or sold by unauthorized dealers may cause hazards.
• Use only on a floor that is a dry, level surface.
• DO NOT use outdoors or on wet surfaces.
• DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. Qualified personnel should perform
all servicing only.
• Connect to properly grounded outlets only.
• Check your heater cord and plug connections.
a) Faulty wall outlet connections or loose plugs can
cause the outlet or plug to overheat. Be sure the
plug fits tight in outlet.
b) Heaters draw more current than small appliances.
Overheating of the outlet may occur even if it has
not occurred with the use of other appliances.
c) During use, check frequently to determine if your
plug outlet or faceplate is HOT!
d) If so, discontinue use of the heater and have a
qualified electrician check and/or replace faulty
outlet(s).
• To reduce the risk of electrical shock, this appliance
has a grounded plug (with a third prong). This plug
will fit in a grounded outlet only one way. If it does not
fit, contact a qualified electrician to install the proper
outlet. Do not change the plug in any way. Do not use
adaptors.
WARNING! - EYE DAMAGE MAY RESULT FROM DIRECTLY VIEWING THE LIGHT PRODUCED BY THE
LAMP USED IN THIS PRODUCT. ALWAYS TURN OFF & UNPLUG UNIT BEFORE OPENING THIS COVER.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
NO USER-SERVICEABLE PARTS INSIDE
SAVE THESE INSTRUCTIONS
* Variables such as your insulation, type and number of
windows, number of stories, construction type, etc. will
greatly affect the required Btu’s per square for heating
CAU TION : Do not power off the heater using
the main power switch or unplugging it, except
in an emergency. A cool down period prevents
damage to the heater before turning off the fan.
By turning off the heater using the main power
switch or unplugging it from the power source, it
does not cool down properly.
SAFETY FEATURES
PRODUCT DIAGRAM
4 5
TIP-OVER SAFETY FEATURE
This heater is equipped with a tip-over safety feature.
Once the heater is tipped over, an internal switch will
automatically shut the heater off. Once the heater
is restored an upright position, the heater will reset.
To continue operation, turn on the heater using the
supplied remote control or the control panel on the
heater.
OVERHEAT SAFETY FEATURE
This heater is equipped with a overheat safety feature.
When the heaters internal components reach a certain
temperature that could cause overheat and possible fire,
the heater will automatically shut off.
AUTO-LOCK FEATURE
Auto-lock can prevent children from changing settings
on the heater. It can be set with the unit either power on,
to prevent changes to the temperature or fan setting, or
power off, to prevent turning the unit on. When locked,
control panel and remote control failed to function.
NOT E: It is normal for the power cord to feel warm
to the touch; however, a loose fit between the outlet
and the plug may cause overheating of the plug. If this
occurs, try inserting the plug into a different outlet.
Contact a qualified electrician to inspect the original
outlet for damage.
IN THE BOX
• SafeHearth™ Portable Heating System
• Remote Control with battery installed
• Owner’s Manual
CONTROL PANEL
1. Maximum temperature indicator: all lights are on when
set at the highest temperature
2. Minimum temperature indicator: bottom light is on
when set at the lowest temperature
3. Remote control signal: window for receiving remote
control signal
4. Temperature down button: for setting temperature
lower
5. Temperature up button: for setting temperature higher
6. High fan speed indicator: light is on when high fan speed
is selected
7. Fan speed button: for selecting fan speed
8. Normal fan speed indicator: light is on when normal fan
speed is selected
9. High heat mode indicator: light is on when High heat
mode is selected
10. Heat buttonfor selecting either Automatic heat mode
or High heat mode
11. Automatic heat mode indicator: light is on when
Automatic heat mode is selected
12. Power button: for power on or off
13. Power supply lightlight is on when the unit is
connected to electric supply
14. Timer buttonfor adjusting the length of time unit runs
and turning on the timer
15. 2 hours indicator: light is on when you set the timer for
2 hours
16. 4 hours indicator: light is on when you set the timer for
4 hours
17. 6 hours indicator: light is on when you set the timer for
6 hours
18. 8 hours indicator: light is on when you set the timer for 8 hours
Loading...