Vogels PFW6850 User Manual
PFW6850
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
www.vogels.com
9531-0016-Z00-02
PFW6850
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
Included components
Prior to initial step 1 of the installation, your PFW6850 can
easily have the main “swing left” pivot point of the main swing
out arm moved to either the center, left or right of the mount
by simply placing the mount on a flat surface and removing
the eight flat head screws, then separating the upper and
lower wall plates.
x4
M5 x 16mm M5 x 25mm M6 x 16mm M6 x 25mm M8 x 16mm M8 x 25mm 5/16” 5/16” x 3”
x4 x4 x4 x4 x4 x4 x4
x4
M10 x 60mm 4mm
2.5mm
10mm
Template
Required for installation
1/4” / 6.5mm
(Wood Only)
3 4A2A1
Set Screw
Locations
Pivot
x8 x4
1/2 ”/14mm
Remove the plastic hole covers from the upper and lower
plates. Loosen the (2) set screws on the plate using the
2.5mm allen key supplied. Reposition the upper and lower
pivot rods to mate to either the center or right side pivot
receiver holes, push the upper and lower plate fully on to the
rods, and re-tighten the set screws. Reinstall the side plate
with the eight flat head screws and confirm they are secure.
Reinstall the round plastic hole covers.
9531-006-Z00-02
Set Screw
Locations
2.5mm
www.vogels.com
PFW6850
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
Using a suitable stud-finder device for frame walls, mark the
position of the stud centers.
Measure the desired height of the center of the screen and
mark it.
1
1
2
2
Take the thick cardboard mounting template supplied and
place the it over the mounting studs with the screen center
facing up. Confirm that the template is level horizontally and
that the wall place outline is to the center of your desired
height.
Using a 1/4” drill bit, drill pilot holes minimum 2” (50mm)
deep into the four marked mounting points on the wall
surface. For solid concrete wall construction, the supplied
plastic wedge anchors are recommend to be used with the
5/16 x 3” lag bolt and washers supplied.
3
1/4” / 6.5mm
Wood Only
To ease the installation process you have the option to
443
remove the wide front plate and mounting brackets by simply
removing the three M5 x 10mm flat head screws, holding
the plate assembly to the swing out arm assembly and setting them aside.
9531-006-Z00-02
www.vogels.com
Loading...