Vogels PFW 6831 User Manual
PFW 6831
Display Wall Mount
For use with Panasonic TH-103PF10UK Series 103” Plasma Displays
INSTALLATION INSTRUCTIONS
9531-0028-Z00-01
Warning Statements 2
Parts List 3
Recommended Installation Tools 3
Features 4
Installation Instructions 4
Warning Statements
INSTALL THE DISPLAY ACCORDING TO THE INSTRUCTIONS PROVIDED BY THE DISPLAY MANUFACTURER.
PERFORM ALL STRUCTURAL REINFORCEMENTS BEFORE ATTACHING THE DISPLAY TO THE WALL. USE
THE APPROPRIATE LIFTING DEVICE WHEN LIFTING THE DISPLAY INTO PLACE.
PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS SHOULD BE READ AND
COMPLETELY UNDERSTOOD. THE INSTALLATION INSTRUCTIONS MUST BE READ TO PREVENT PERSONAL INJURY AND
PROPERTY DAMAGE. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE
REFERENCE.
VOGEL’S DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY VOGEL’S PRODUCT
FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY UNAUTHORIZED ATTACHMENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DAMAGES, CLAIMS, DEMANDS, SUITS, ACTIONS OR
CAUSES OF ACTION OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR IN ANY MANNER RELATING TO ANY
SUCH USE, ATTACHMENTS OR MODIFICATIONS.
THE WALL STRUCTURE MUST BE CAPABLE OF SUPPORTING 907 KG IF NOT, THE WALL STRUCTURE MUST BE
REINFORCED. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE
INSTALLATION INSTRUCTIONS, MUST BE ADHERED TO. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL
INJURY, OR EVEN DEATH.
SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE INSTALLATION OF THIS PRODUCT. USE PROPER
SAFETY GEAR AND TOOLS FOR THE INSTALLATION PROCEDURE TO PREVENT PERSONAL INJURY.
PFW 6831
Table of Contents
8
Indicates that the power plug is to be disconnected
from the power outlet.
Safety precautions must be taken at all times.
Warning and Caution statements.
It is recommended that a maximum of 5/8” thick plaster board be used, along with 5/16” lag bolts and washers, when mounting to wooden
studs.
In the interest of safety, it is recommended that two to three people, with the aid of an appropriate assisted lifting device, perform this
THIS MOUNT IS NOT RECOMMENDED FOR USE
WITH STEEL STUD WALL STRUCTURES THAT
ARE LESS THAN 10 GAUGE IN THICKNESS ON
THE PROPOSED INSTALLATION WALL.
Page 2 Installation Instructions
Parts List
PFW 6831
This wall mount is shipped with all proper installation hardware and components. Make sure that none of these parts
are missing and/or damaged before beginning installation.
Mounting Brackets (Qty 2)Wall Mounting Plates (Qty 2)
5/16” x 3” Lag
Bolts (Qty 16)
5/16” Tri-Lobe Anchor
(Qty 16)
Recommended Installation Tools
1/4” Wood Pilot Drill Bit
Side Straps (Qty 2)
Drill
Pencil
m5x.8x12 Phillips Head Screws (Qty 8)
5/16” Flat Washers
(Qty 16)
Tape Measure
Spirit Level (Supplied)
3/8” Concrete
Drill Bit For use
Ladder
with 3/8” concrete
wedge anchors)
1/2” Socket and Wrench
#2 Phillips Screwdriver
Stud Finder
Installation Instructions Page 3
Loading...