VODAFONE AUTOMOTIVE 5481 Manual alarm
G031385
XC60 (Y413); 1; 4 2008-06-30T12:08:01+02:00; Page 65
henrikrosenqvist
02 Locks and alarm
Alarm
The alarm system
The alarm is automatically armed whenever the
vehicle is locked with the remote key or
optional Personal Car Communicator.
When armed, the alarm continuously monitors
a number of points on the vehicle. The following conditions will trigger the alarm:
The hood is forced open.
•
The tailgate is forced open.
•
A door is forced open.
•
The ignition slot is tampered with.
•
An attempt is made to start the vehicle with
•
a non-approved key (a key not coded to
the car's ignition).
If there is movement in the passenger com-
•
partment (if the vehicle is equipped with
the accessory movement sensor).
The vehicle is lifted or towed (if the vehicle
•
is equipped with the accessory inclination
sensor).
The battery is disconnected (while the
•
alarm is armed).
The siren is disconnected when the alarm
•
is disarmed.
A message will appear in the information display if a fault should occur in the alarm system.
Contact an authorized Volvo service technician.
NOTE
Do not attempt to repair any of the components in the alarm system yourself. This
could affect the insurance policy on the
vehicle.
The alarm indicator light
The status of the alarm system is indicated by
the indicator light on the dashboard (see illustration):
Indicator light off – the alarm is not armed
•
The indicator light flashes at one-second
•
intervals – the alarm is armed
The indicator light flashes rapidly before
•
the remote key is inserted in the ignition
slot – the alarm has been triggered.
Arming the alarm
–
Press the Lock button on the remote key.
One long flash of the turn signals will confirm that the alarm is armed.
Alarm confirmation settings can be changed
under Car settings
Keyless entry. See page 120 for a description
of the menu system.
Lock settings
USA FCC ID: MAYDA 5823(3)
This device complies with part 15 of the FCC
rules. Operation is subject to the following conditions: (1) This device may not cause harmful
interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Canada IC: 4405A-DA 5823(3)
Movement sensor DA5823 by Dynex Operation
is subject to the following conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation of the device.
02
}}
65
G031384
XC60 (Y413); 1; 4 2008-06-30T12:08:01+02:00; Page 66
henrikrosenqvist
02 Locks and alarm
Alarm
Disarming the alarm
–
02
Press the Unlock button on the remote key.
> Two short flashes from the car's direc-
tion indicators confirm that the alarm
has been deactivated and that all doors
are unlocked.
Turning off (stopping) the alarm
If the alarm is sounding, it can be stopped by
pressing the Unlock button on the remote control or by inserting the remote key in the ignition
slot. Two short flashes from the car's direction
indicators confirm that the alarm has been
turned off.
Other alarm-related functions
Automatic re-arming
If the doors are unlocked, the locks will automatically reengage (re-lock) and the alarm will
re-arm after 2 minutes unless a door or the tailgate has been opened.
Audible/visual alarm signal
An audible alarm signal is given by a bat-
•
tery powered siren. The alarm cycle lasts
for 30 seconds.
The visual alarm signal is given by flashing
•
all turn signals for approximately 5 minutes
or until the alarm is turned off.
Remote key not functioning
If the remote key is not functioning properly,
the alarm can be turned off and the vehicle can
be started as follows:
1.
Open the driver's door with the key blade.
This will trigger the alarm.
2. Insert the remote key into the ignition slot.
This will turn off the alarm.
Reduced alarm function
Turning off the accessory alarm sensors
Navigation (left/rght/up/down) buttons
ENTER
MENU
EXIT
In certain situations it may be desirable to turn
off the accessory inclination and movement
alarm sensors if, for example, you drive your
vehicle onto a ferry where the rocking of the
boat could trigger the alarm or if a pet is left in
the vehicle with the doors locked.
The vehicle's menu system is used for turning
off these sensors (See page 120 for a description of the menu system).
1.
Go into the menu under Car settings.
2.
Select Reduced guard (Press Enter to
choose).
3. Two alternatives are now available:
Activate once. If this alternative is
•
selected, Reduced guard–see
manual will appear in the instrument
panel display and the accessory inclination and movement alarm sensors will
be deactivated when the vehicle is
locked.
Ask on exit. If this alternative is
•
selected, the message Press ENTER
to reduce guard until engine is
started—Press EXIT to cancel will
appear in the center console display
each time the engine is turned off and
the accessory inclination and movement alarm sensors will be deactivated
when the vehicle is locked.
66
Loading...