VMP Z-MOUNT User Manual

Instruction Sheet For:

Z-MOUNT

For more information, please contact us at:

345 Log Canoe Circle, Stevensville, Maryland 21666

Toll Free: 877.281.2169 Phone: [phone] Fax: [phone]

www.videomount.com

Step 2 and 3: Attaching the

support to the chimney

Step 1

Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before at-

tempting to assemble the mount. Note: It is highly recommended

that the installation of this mount be done by a professional.

Step 2

Take the support and place the 90 degree angle on the corner

1

of the rectangular chimney. Take the triangle screw attached the
steel strap and insert it through the hole in the support

6

1

close to the chimney on the side which has the “V” nock in it. Use
a hex nut to secure the triangle screw. Wrap the strap

2

6

around the chimney. Note: When wrapping the band around the
chimney, make sure the strap is resting on the brick and not on the
mortar seem as this will provide a better mounting surface.

Step 3

Slide the strap through the connect component . Then take
the free triangle screw and insert it through the support in the

3

other hole which is close to the chimney. Use a hex nut to se­cure the screw . Wrap the free end of the strap through the
triangle screw and then take the free end of the strap and slide
it back through the connect component . Pull the strap tight

3

3

5

and crimp the ears of the connect component down to hold the
strap in place. Tighten down hex nuts until all slack is removed
from the strap . Repeat steps 2 and 3 for the other support .

6

2

Note: Place the other support as far away from the fi

56

1

2

6

6

5

1

rst support as
possible to give the antenna mast more stability. WARNING: Please
verify your mounting surface will support the combined weight of
your mount, mounting hardware and antenna. If in doubt, please
contact a professional installer.

Step 4: Attaching the antenna

mast to the support

Step 4

Place the antenna mast into the “V” notch in the supports . Use
the “U” bolts and hex nuts to secure the mast to the supports
. Use the cable ties as desired to secure loose wires.

1

4

7

2

1

Please verify that all nuts and screws are securely tightened and
the connect component is fi rmly crimped down.

Enjoy Your Mount!

WARNING: The installer must verify the installation meets all ap­plicable codes and survival requirements. Video Mount Prod­ucts will not be held liable for the improper use or installation of
its products.