VMP Y-MOUNT User Manual

Instruction Sheet For:

Y-MOUNT

For more information, please contact us at:

345 Log Canoe Circle, Stevensville, Maryland 21666

Toll Free: 877.281.2169 Phone: [phone] Fax: [phone]

www.videomount.com

Step 2 and 3: Attaching the

support to the chimney

Step 1

Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before at­tempting to assemble the mount. Note: It is highly recommended

that the installation of this mount be done by a professional.

Step 2

Take the support and place the wide opening onto the circu­lar chimney. Take the triangle screw attached the steel strap )
and insert it through a hole in the support on the fl aps close
to the chimney. Use a hex nut to secure the triangle screw.
Wrap the strap around the chimney. Note: When wrapping

1

6

1

2

6

the band around the chimney, make sure the strap is resting on a
solid surface which will support the weight of the combined load of
the antenna mast and mount.

Step 3

Slide the strap through the connect component . Then take
the free triangle screw and insert it through the support in the

3

other hole which is close to the chimney. Use a hex nut to se­cure the screw . Wrap the free end of the strap through the
triangle screw and then take the free end of the strap and slide
it back through the connect component . Pull the strap tight

3

3

5

and crimp the ears of the connect component down to hold the
strap in place. Tighten down hex nuts until all slack is removed
from the strap . Repeat steps 2 and 3 for the other support .

6

2

56

1

2

6

6

5

1

Note: Place the other support as far away from the fi rst support as
possible to give the antenna mast more stability. WARNING: Please
verify your mounting surface will support the combined weight of
your mount, mounting hardware and antenna. If in doubt, please
contact a professional installer.

Step 4: Attaching the antenna

mast to the support

Step 4

Place the antenna mast on the fl ap portion of the supports . Use
the “U” bolts and hex nuts to secure the mast to the supports
. Use the cable ties as desired to secure loose wires.

1

4

7

2

1

Please verify that all nuts and screws are securely tightened and
the connect component is fi rmly crimped down.

Enjoy Your Mount!

WARNING: The installer must verify the installation meets all ap­plicable codes and survival requirements. Video Mount Prod­ucts will not be held liable for the improper use or installation of
its products.