Page 1
Instruction Sheet For:
PM-LPM & PM-LPMB
For more information, please contact us at:
345 Log Canoe Circle, Stevensville, Maryland 21666
Toll Free: 877.281.2169 Phone: 410.643.6390 Fax: 410.643.6615
www.videomount.com
Page 2
15
7
14
PM-LPM
13 1
19
17
2
11
4
8
10
6
3
4
1
1
QTY.
Pipe Couple
DESCRIPTION
1
1
Mid Plate
Lower Plate
Upper Plate
Plastic Bushings
12
1
4
4
4
4
16
Leg
Foot
Bottom Plate
Longer Foot
16
9
1
4
4
4
2
8
12*T1.0
6.5*
20UNC*L3/8"
Brake Screw 1/4"-
M3 Allen Key
1
1
Ceiling Plate
M4 Allen Key
5
18
NO.
ITEM
Washer
Wing Screw M6*P1.0*L10
Socket Screw M6*P1.0*L12
6
7
8
4
1
2
5
3
9
10
11
12
13
Cross Screw M6*P1.0*L12
Cross Screw M5*P0.8*L12
Cross Screw M4*P0.7*L12
19
18
17
16
15
14
Page 3
Step 2: Attaching the feet to
the projector
Step 3: Attaching the feet to
the mount
Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
Attach the feet or to the projector using the appropriate
screws or .
13
8
14
9
Step 3
Attach the feet or to the legs using the wing screws
10
. Note: If you plan to feed the cables through the holes in
8
9
7
the center of the mount itself take the time to do so now before
proceeding further. Note: If using the longer feet use the
M6 screws in the rear holes of the feet in addition to the wing
screws to better secure the longer foot.
15
10
9
If you are using the ceiling plate (#19) otherwise proceed to step 5.
Step 4
Mark the ceiling or desired mounting surface in preparation of installation of the ceiling plate . Pre-drill, if necessary, and mount
the ceiling plate to the desired surface. WARNING: Please ver-
19
19
ify that your mounting surface can support the combined weight of
your mount, mounting hardware and projector. Also verify that the
mounting surface is safe to drill through. If in doubt, please contact
a professional installer.
Step 4: Attaching the ceiling
plate to the mounting surface
Step 5: Attaching the mount
to the 1.5” NPT pipe
Step 5
Attach the 1.5” NPT pipe to the pipe couple . Tighten the brake
screw into the pipe to secure in place. If you use the ceiling
plate provided, secure the other end of the 1.5” NPT pipe into
the ceiling plate by tightening the second brake screw in
12
19
19
1
12
the other end of the pipe.
Please verify that all nuts and screws are securely tightened.
Enjoy Your Mount!
WARNING: The installer of these products must verify that the mount
surface, ceiling or wall, will safely support the combined weight of
all attached equipment and hardware. Video Mount Products will
not be held liable for the improper use or installation of its products.
Loading...