VMP P-6 User Manual

Instruction Sheet For:

P-6

For more information, please contact us at:

345 Log Canoe Circle, Stevensville, Maryland 21666

Toll Free: 877.281.2169 Phone: [phone] Fax: [phone]

www.videomount.com

Step 2: Attaching the welded

bracket to the top plate

Step 1

Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount. Note: It is highly recommend-

ed that the installation of the mount be done by a professional.

Step 2

Create Y shapes by taking two Plate Bs and using the 1” long
screw and 2” long screw in the hole shown in the diagram
with hex nuts .

5

7

4

2

Step 3

Attach the Y shapes to the vent pipe by pressing the V to the pipe
and placing Plate A on the back side of the vent pipe. Then
use the 5 ½” long screws and hex nuts to clamp the Y
shapes and Plate As to the vent pipe.

1

3

7

Note: Place the other sup­port as far away from the fi rst support as possible to give the antenna
mast more stability. WARNING: Please verify your mounting surface
will support the combined weight of your mount, mounting hardware
and antenna. If in doubt, please contact a professional installer.

Step 3: Attaching the top

plate to the mounting surface

Step 4

Insert the antenna mast into the open mouth on the Y shapes. Use
the remaining 2” long screws and hex nuts to clamp the

4

7

antenna mast in place.

Please verify that all nuts and screws are securely tightened.

Step 4: Clamping the antenna

mast in place

Enjoy Your Mount!

WARNING: The installer must verify the installation meets all ap­plicable codes and survival requirements. Video Mount Prod­ucts will not be held liable for the improper use or installation of
its products.