VMP DS-CH User Manual

Instruction Sheet For:

DS-CH

For more information, please contact us at:

345 Log Canoe Circle, Stevensville, Maryland 21666

Toll Free: 877.281.2169 Phone: [phone] Fax: [phone]

www.videomount.com

7

3

2

1

QTY.

5

1

DS-CH

1

6

1

1

4

2

6

Security Box

DESCRIPTION

Connector Flap

1

2

ITEM NO.

Security Strip

Security Screw M6*P1.0*L12

3

4

25*T2.0

8.5*

Security Allen Key

Washer

Flat Head Screw M6*P1.0*L12

5

6

7

Step 2: Inserting the computer

Step 3: Attaching the connector fl ap

Step 1

Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount. Note: In the instruction sheet

the FP-LDSB is used as an example of a mount which the DS-CH
can attach to. Other mounts maybe used as desired.

Step 2

Insert the digital signage computer into the DS-CH by fi rst remov-
ing the security screws from one of the security box’s lids.

3

1

Insert the computer and run the cables out through the semicircle
cut into the lid as you close the security box . Secure the lid by
rescrewing the security screws into the security box’s lid.

3

1

1

Step 3

Attach the connector fl ap to the security box on the desired

2

side and location using the security screws .

1

3

Step 4

Attach the fl ap to the mounting rails of the desired mount (FP-

2

LDSB mounting rails shown in images). If the fl at panel the box
will be behind is going to be mounted in landscape use the two
countersunk holes closest to the box on the fl ap . If the fl at panel

2

is going to be mounted in portrait use the hole furthest from the
box the one in line with that one. Attach it to the mounting rail by
inserting the countersink screws into the appropriate counter­sink holes in the connector fl ap . Then on the backside of the
mounting rail thread the countersink screws into the security

4

strip so that the mounting rail is sandwiched between the con­nector fl ap and security strip .

2

6

2

6

4

Step 4A: Attaching the box to the mounting rail

(fl at panel in landscape)

Step 4B: Attaching the box to the mounting rail

(fl at panel in portrait)

Step 5

Proceed to follow the mounting instructions for the mount you are attaching the DS-CH to until you get
to the point where you are attaching the fl at panel to the mounting rails. At that point the only differ-
ence between the instructions provided with the other mount and the DS-CH is since the connector

2 2 7

fl ap will create a standoff of the thickness of the connector fl ap you can use the washers as
spacers so the fl at panel will still have an even surface to mount on.

Please verify that all nuts and screws are securely tightened.

Step 5a: Attaching the mounting rail to the fl at panel

(fl at panel in landscape)

Enjoy Your Mount!

Step 5b: Attaching the mounting rail to the fl at panel

(fl at panel in portrait)

WARNING: The installer of these products must verify that the mount surface, ceiling or wall, will safely
support the combined weight of all attached equipment and hardware. Video Mount Products will not
be held liable for the improper use or installation of its products.