VM5 Lighting Solutions MAXIM FMVT-40-48-C, MAXIM MVT-40-38-C, MAXIM MVT-50-38-F, MAXIM MVT-40-48-F, MAXIM MVT-50-48-C Installation Instructions Manual

VM5 Lighting Solutions

INSTALLATION INSTRUCTION

13100 Alondra Blvd.,#106,Cerritos,CA
90703 Email:[e-mail]

Toll Free:844.VM5.Light

INSTALLATION INSTRUCTIONS

MA X I M

LED VAPOR TIGHT - WATERPROOF

Features:

Product name: Vapor Tight

IP66 Rated

Suitable for Damp & Wet locations,All Indoor Applications
Operating voltage: AC 120-277 50/60HzV

Driver: Meanwell driver
LED Type:Samsung 5630

TM

Technical data:

1951 S. Parco Ave., Unit A

Ontario, CA 91761

Tel: [phone] | (1.844.VM5.LIGHT) | Fax: [phone]

SERIES

Model Power L(inch) W(inch) H(inch) LF(inch)

MVT-40-38-C

MVT-40-38-F
MVT-50-38-C
MVT-50-38-F

MVT-40-48-C
MVT-40-48-F
MVT-50-48-C
MVT-50-48-F
MVT-50-75-C
MVT-50-75-F

38W

48W

75W

45.7

61.4

4.7 4.3

4.7 4.3

LF

30

43

Safety Notice:

1.Electrical installation should be performed by a licensed electrican only

2.Disconnect the luminaire from the power supply and let cool down before any

maintenance is performed.All maintenance should be performed by a

lisensed electrician only!

3.Never touch the LED’s while luminaire is energized

4. Please contact your local representative for more information

Instruction of installation:

E

F

1.Snap the fixture into the mounting clips. Confirm that the fixture is
securely mounted

G

Turn on the power

Affix gear tray to the housing

2.If wall mounted,suitable for mounting within 4 ft of the ground

These waterproof luminaires may be wall mounted (Above 4 ft from the ground)
or ceiling mounted, are IP66 rated, and are suitable for damp and wet location
applications,as well as all indoor applications

Note:DO NOT drill holes on any part of the luminaire

Mounting

Drill 0.234 hole and press 6x30 screw anchor in the wall,fix the mounting bracket
on the wall by St4x30 bolt

B

Insert screw anchor in the mounting surface,

Turn off the power

attach mounting brackets with screws

0.2 34inc h

C

Open the clips See A below

D

OFF

1i nc h

Remove diffuser See B below

Remove gear tray See C below

Affix gear tray to the housing

E

1.Snap the fixture into the mounting clips. Confirm that the fixture is

F

securely mounted

Suspending Mounted

2.If wall mounted,suitable for mounting within 4 ft of the ground

Turn on the power

G

ON

VM5 Lighting Solutions

INSTALLATION INSTRUCTION

Features:

Product name: Vapor Tight

IP66 Rated

Suitable for Damp & Wet locations,All Indoor Applications
Operating voltage: AC 120-277 50/60HzV

Driver: Meanwell driver
LED Type:Samsung 5630

Technical data:

Model Power L(inch) W(inch) H(inch) LF(inch)

MVT-40-38-C

MVT-40-38-F
MVT-50-38-C
MVT-50-38-F

MVT-40-48-C
MVT-40-48-F
MVT-50-48-C
MVT-50-48-F
MVT-50-75-C
MVT-50-75-F

Safety Notice:

1.Electrical installation should be performed by a licensed electrican only

2.Disconnect the luminaire from the power supply and let cool down before any

maintenance is performed.All maintenance should be performed by a

lisensed electrician only!

3.Never touch the LED’s while luminaire is energized

4. Please contact your local representative for more information

13100 Alondra Blvd.,#106,Cerritos,CA
90703 Email:[e-mail]

Toll Free:844.VM5.Light

ON-OFF Function:

4

Introduction:

Automatic switching based on motion and light level.
This is an

innovative motion sensor, switch on the light on detection of movement,
and switch off after a hold time when there is no motion detected. Aa built-in
daylight sensor can read brightness value, the sensor does not switch on the
light if with sufficient natural light.

Operating voltage 120~277Vac, 50/60Hz

120V AC: 200W(inductive), 400W (resistive),

220-240V AC:

Rated load

277V AC: 400W(inductive), 800W (resistive)

HF system 5.8GHz±75MHz, ISM wave band

Transmitting power <0.5mW

Power consumption ≤0.5W(standby), <1W(operation)

Detection zone Max.(D x H): 10m x 6m

Detection sensitivity 25% / 50% / 100%

Hold time 5s / 1min / 5min / 15min / 30min

Daylight sensor 5lux / 10lux / 20lux / 30lux / 50lux /Disable

Mounting height 8m Max.

Motion detection 0.5~3m/s

Detection angle 150°(wall installation)

360°(ceiling installation)

Operating temperature -20℃~50℃

IP rating IP20

400W(inductive), 800W (resistive)

Setting

By selecting the combination on the DIP switch,sensor data can be precisely set for
each specific application.

100%

50%

25%

1 2 3

1min

5min

15min

30min

1 2 3 4

Detection area

Detection area can be red uced by selec ting the combination o n the
DIP switches to fi t precise ly each application.

Hold time

5S

Refers to the time period the lamp remains at 100% illumination after
no motion detected.

Daylight sensor

5lux

The sensor can be set to only allow the lamp to illu minate below a

10lux

20lux

defined ambient br ightness threshold.

30lux

When set to Disable mo de, the daylight sen sor will switch on the lamp

50lux

Disable

when moti on is detec ted regard less of ambient light level.