Viz-Art Automation SPAV Series, SPAV 30/420, SPAV 30/780, SPAV 30/1560, SPAV 30/1960 Installation Manual

1. INSTALLATION:

A. Determine the mounting location for the lift in the

structural ceiling using the template (transport plate A). Drill
holes and insert wall plugs (included in the mounting kit).

B. Raise the lift and fit it to the structural ceiling using

screws (marked B).

C. Install the universal projector bracket using screws included

in the mounting kit.

D. Mount the projector along with the mounting

component (adaptor) to the base of the lift –
mechanical platform. “C” openings in the platform

allow you to adjust the projector mounting distance.

1/5

SPAV LIFT

Projector lift:

•SPAV 30/420; •SPAV 30/780; •SPAV 30/1560; •SPAV 30/1960;

•SPAV 30/2800; •SPAV 30/3500; •SPAV 30/4200

3 or 4
points
mounting
system

LIST OF COMPONENTS:

 Lift
 Ceiling closure panel
 Push-button switch
 Installation template
 Installation manual
 Mounting kit

E. Turn on the projector and adjust the position of image on

the screen by rotating the adaptor.

2. MOUNTING THE CLOSURE PANEL:

A. Screw threaded studs D – 4 pcs (included in the kit) – into

closure panel openings – marked E.
Note! The opening, through which the lift slides out of the
suspended ceiling must be larger by 6-10 mm for each side of
the ceiling closure panel.

B. Mount the panel along with studs to the mobile

platform of the lift and tighten nuts F – 4 pcs (included
in the kit), also using washers „G”.

3. SETTINGS AND ADJUSTMENT:

1. TOP STOP (the lift with the projector are retracted above

the ceiling).

Adjustment knob – marked A – is used to adjust the top

stop position. Turn knob A clockwise in order to raise the

lift’s top stop. Turn knob A anti-clockwise in order to lower

the lift’s top stop.

Set limit switches using knob A so that, after the lift stops,

the closure panel is flush with the suspended ceiling – as

shown in the drawing.

2. BOTTOM STOP (the lift with the projector are lowered

to the operating position).
Turn adjustment knob B clockwise in order to raise the

lift’s stop. Turn knob B anti-clockwise in order to lower
the lift’s stop.

Set limit switches using knob B so that, after the lift
stops, the projector displays the image evenly on the
screen.

2/4