Viz-Art Automation LEADER Mount Installation Manual
1. Installation:
A. Prepare an installation place and mark mounting points
using installation template as below:
Install mount to the ceiling
B. Install projector on universal projector adapter. Use
mounting screws from mounting set.
Warning! To connect the mount with the projector, select
the appropriate screws from the mounting kit according to
the recommendations of the projector manufacturer.
C. Joint adapter with installed projector with projector mount
as described below using middle hanger. Block projector on
a mount with screws in holes A.
D. Check and adjust proper projected image. If needed
adjust projector image on a ceiling mount.
LEADER Mount
Universal projector mount:
• Direct
• Adjusted 48 – 74
• Adjusted 66 – 110
• Adjusted 120 - 200
1/2
LIST OF ITEMS:
Projector mount:
Universal projector adapter
Adjusted arm (mount with arm)
Mounting set
Installation manual
Mounting template
2. Adjusting projector on a ceiling mount:
A. Adjusting height of installed projector: Loosen screw B and
adjust expected height of projector. tighten screw- B. In
Direct Mount height is non adjustable
B. Pitch axis adjustment.
If projected image is to low or high on the screen/vertical
distortion/, Loosen screws C and tilt projector to expected
vertical position. Tighten screws C, when finished
C. Yaw axis adjustment.
If projected image is to right or left on the
screen/horizontal distortion/,– rotate projector on a screw
D.
D. Roll axis adjustment.
Loosen screws E. then adjust the projector mount’s roll
adjustment such that the top and bottom edges of the
image are approximately horizontal and aligned with
the top and bottom of the screen. Tighten screws E,
when finished.
3. Technical Specification:
Product model:
LEADER Mount
Adjustment:
góra-dół 15 stopni
prawo-lewo 15 stopni
Poziom 18 stopni
Pochylenie 56 stopni (z wys.)
Weight:
LEADER Mount bezpośredni 1,1 kg
LEADER Mount 48 -74 z wys. 3 kg
LEADER Mount 66-110 z wys. 4 kg
LEADER Mount 120-200 z wys. 6,5 kg
4. Mounting kit set :
Śruby:
M4x12 – 4 szt.;
M5x12 – 8 szt.;
M6x12 – 4 szt.;
Podkładki:
ø6x12 – 8 szt.;
ø5x10 – 4 szt.;
Kołki rozporowe:
ø8x40 – 4 szt.
Wkręty:
ø5x40 z płaskim łbem – 4 szt.
manufactured: VIZ-ART Automation
tel.+48 22/6138899 www.viz-art.pl
2/2
Loading...