ViVOtech 030XXEMV Users Manual
FCC Regulatory Compliance: Notices Class B Equipment: This
Danger of explosion if battery is incorrectly replaced.
Replace only with same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturers instructions.
equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
WARNING:
1.The ViVOpay hardware or software can not be replaced or modified by any third party
!
other than VIVOtech. Changes or modifications not expressly approved by ViVOtech
could void the user's authority to operate the equipment.
2. Minimum separation distance between 2 ViVOpay devices should be at least 2 feet.
3.The device should be mounted and seated on a non metal surface and be at least 6
inches far from any metal surface.
pay
USER GUIDE
3000
TM
EMV
TM
Quicker than cash, Safer than checks
www.vivotech.com
SM
ViVOtech Corporate Headquarters
451 El Camino Real, Santa Clara, CA
95050. Phone: 888-363-3753
Version 1.1 January 2004 Copyright 2004 ViVOtech, Inc.
TM
Quicker than cash, Safer than checks
SM
Quicker than cash, Safer than checks
www.vivotech.com
SM
TM
to the consumer for signature as with any other purchase.
Consumers just need
to hold their Paypass
devices in front of
the ViVOpay
the ViVOpay.
enters the items into the cash register, and once done, asks the consumer for the form
of payment and mentions the contactless payment option by pointing to the ViVOpay.
2. The consumer pulls it's contactless cell phone or plastic card and holds it in front of
3. The ViVOpay quickly reads the information from the card
through RF technology - no physical contact is necessary. In
a fraction of a second the reader validates the card, and
secures the transaction.
(As the reader is facing the customer and probably the clerk
won't be seeing the LEDs, a beep will let the clerk know that
the read was successful).
4. ViVOpay 3000 Plus automatically sends the information to the
POS, which processes it as a conventional magnetic stripe
card, though with increased security.
(Besides mentioning contactless payments and pointing to
the ViVOpay unit no intervention from the clerk is necessary
during the entire procedure).
5. The POS terminal prints the receipt, which the clerk gives
Typical Usage
1. The customer approaches the clerk with one or more items to purchase. The clerk
it communicates with it and retrieves the payment information. The card information is
then transmitted to the POS device via the Dynamic Strip
TM
or direct serial connection.
securely release the payment information to the ViVOpay terminals without the need
of physical contact with the Point of Sale terminal using contactless technology.The
ViVOpay is constantly emitting a magnetic field, when it detects an RF tag in the field
How it Works
Contactless devices as cell phones and plastic cards are enabled with RF tags that
transferred to POS system and processed in the same way a standard magnetic card
would be.
automated. Once installed, the clerk's role on the operation of the system is simply to
guide new customers to hold their cell phones or plastic cards enabled with a
contactless RF chip in front of the Reader Module. The information is automatically
ViVOpay 3000 EMV User Guide
The merchant operation of the ViVOpay 3000 EMV is very simple and almost entirely
Read SUCCESS: all LEDs will be turned
on while the module emits a sound
Read ERROR: If there's an error while
reading a card the LEDs will not turn
On and no sound will be emitted
ViVOtech Corporate Headquarters
451 El Camino Real, Santa Clara, CA
95050. Phone: 888-363-3753
acknowledging the success.
Idle: Just first LED is ON
interface to provide consumers feedback on the read process. Upon a successful
transaction all 4 LEDs will turn on and a beep will sound to let the customer know
that the transaction is completed.
LEDs and Sound
The ViVOpay is equipped with 4 LEDs on it's translucent cover as well as sound
Loading...