Vitesse VS-218 User manual

Dear Customer!

You have made an excellent decision. ViTESSE® home range offers you an exclusive,
high quality range of appliances for your ultimate home luxury and healthy living.

GENERAL DESCRIPTION

A. Pusher

B. Feeding Tube

C. Lid

D. Filter

E. Juice Collector

F. Pulp Container

G. Clamps

H. Control Knob

I. Driving Shaft

J. Motor Unit

IMPORTANT:

Read these instructions for use carefully before using the appliance and save them for
future references.

• Do not use the appliance when the mains cord, the plug or other components are
damaged. If so, please check with an authorized service center for repair

• This appliance is intended for household use only

• Keep the appliance out of the reach of children.

• Make sure all parts are mounted correctly, and both clamps are locked before you
switch on the appliance

• Do not operate the juicer for more than two minutes at a time when juicing heavy loads
and let it cool down for Ѕ min before reuse.

• Never reach into the feeding tube with your fingers or any sharp object while the
appliance is running only the pusher is to be used for this purpose.

• Never immerse the motor unit in water or any other liquid. Do not rinse it either.

VS-218 / Service Manual / General Description

1

PREPARING FOR USE:

The appliance is equipped with a safety system. It won't work if the parts
have not been mounted properly.

1 . Place the juice collector in place.

2. Place the pulp container into the appliance by tilting it forwards slightly,
then it is pushed home as shown.

3. Put the filter in the juice collector. Make sure the filter is fitted securely
onto the driving shaft “Click”.

4. Hold the lid over the filter and lower it into position.

5. Snap the two clamps onto the lid to lock it into place “click”. Make sure
the clamps are locked into position on either side of the lid.

6. Slide the pusher into the feeding tube by allgning the groove in the
pusher with the small protrusion on the inside of feeding tube.

2

VS-218 / Service Manual / Preparing for use

www.vitessehome.ru

USING THE APPLIANCE

1. Wash the fruit and/or vegetables and cut them into pieces that fit onto
the feeding tube.

2. Make sure the juice jug has been placed under the spout. Switch the
appliances on.

3. Put the pre-cut pieces in the feeding tube and gently press them down
towards the rotating filter by means of the pusher. After the juice flow
has stop, switch the appliance of and wait until the filter has stopped
rotating. Never insert your finger or an object into the feeding tube.

CLEANING

· The appliance is easier to clean if you do so immediately after use.

· Do not use abrasive cleaning agents, scourers, acetone, alcohol, etc. to clean the
appliance.

· All detachable parts are dishwasher safe.

1 Switch the appliance off, remove the plug from the wall socket and wait until the filter has

stopped rotating.

2 Remove the dirty parts from the motor unit.

Disassemble the appliance in the following order:

• Remove the pulp container

• Remove the pusher

• Open the clamps

• Remove the lid

3 Remove the juice collector together with the filter
4 Clean these parts with the cleaning brush in warm water with some washing up liquid and

rinse them under the tap

5 Clean motor unit with a damp cloth. Never immerse the motor unit in water nor rinse it under

the tap.

VS-218 / Service Manual / Using the appliance

3

Problem

Solution

The appliance does not
work.

The motor unit gives off an
unpleasant smell the first
few times the appliance is
used.

The appliances makes a lot
of no ise, gi v es off an
unpleasant smell is too hot
to touch gives off smoke
etc.

The filter is blocked

The filter t o u c h e s the
feeding tube or vibrates
strongly during processing

The appliance is equipped with a safety
system. It won't work if the parts have not
been mounted properly. Check whether
the parts have been assembled in the
right way, but switch off the appliance
before you do so.

This is not unusual. If the appliance
continues to give this smell after a few
times, check the quantities you are
processing and the processing time.

Switch the appliance off and unplug it.
Check with the service center.

Switch and appliance off, clean the
feeding tube and the filter and process a
smaller quantity.

Switch the appliances off and unplug it,
check if the filter has been properly
placed in the juice collector. The ribs in the
bottom of the filter should fit properly onto
the driving shaft. Check if the filter is
damaged. Cracks, crazes, a loose grating
disc or any other irregularity may cause
malfunction.

TECHNICAL SPECIFICATIONS

Rating voltage: 220-240V ~ 50Hz
Power: 600W

4

VS-218 / Service Manual / Technical specifications