Vitek VTD-TND5RFE-2, VT-TND5CKTFE-2 Quick Start Guide
VTD-TND5RFE-2
MegaPixel Indoor/Outdoor WDR
IP Camera with IR LED Illumination
Transcendent Series 5
VITEK
QUICK START GUIDE
VITEK
FEATURES
• 1/2.7” 5.0 MegaPixel CMOS Image Sensor
• Up to 20fps live view @ 5 MegaPixel (2592x1944)
• 2.8mm Fixed Iris Lens
• 16 Infrared LEDs with a 65’ IR Range
• Digital Wide Dynamic Range (D-WDR)
• True Mechanical Day/Night function by ICR
• XD-DNR (3D-DN & 2D-DNR) Noise Reduction
• On Board Motion Detection, Privacy Masking, and Region of
Interest
• H.265, H.264 & MJPEG Compression
• Remote Viewing via CMS, Internet Explorer, and iOS & Android
Apps
• ONVIF Compliant
• IP66 Weather Resistance
• Optional Junction Box Mount (VT-TJB03A) and Wall Mount
(VT-TWMT-3) Available
• 12VDC & PoE (Power over Ethernet) Operation
PLEASE NOTE:
Complete User Guide, Software, Tools, and Updates are
available online. Scan the QR Code or visit:
http://www.vitekcctv.com/Downloads
Components and Accessories
Cam era
Hex Wrench
Overview
Qui ck
s tart guide
Dri ll te mplat e
4 tappi ng sc rews PA 4×25
p lug × 4
Pla stic
Network Cable
Power Cable
Security Cap
Cable Connections
First connect the Waterproof Cap to an Ethernet
patch cable, then
connect the cameras
ethernet adaptor. If not
powering the camera
DC12V
with PoE, also connect
the power Cable to an
approved 12VDC Power
Supply.
Weather Resistant Network Coupler
Rub ber plu g
1. Loosen the nut from the Weather Resistant Network Coupler,
2. Run ethernet cable through coupler, then attach a RJ-45 connector.
3. Tighten the nut and coupler for a weather resistant seal.
2 3
Installation
Before beginning installation, make sure that the wall or ceiling is
strong enough to withstand 3 times the weight of the camera. The
mounting steps are as follows:
(mm)
1. Attach the drill template to
the place where you want to
install the camera, then drill
the screw holes and 1 cable
hole according to the drill
template.
2. Loosen the screws to open
the lower dome.
3. Route the cables and
connect the power & video
cables, use the rubber plug
to fill the gap of the mounting
base. then secure the
mounting base to the ceiling
or wall with screws.
74.25
4.25
7
Lower Do me
Rubber P lug
3
Loading...