Vitek DVR-960S, DVR-96T, DVR-96H, DVR-96D, DVR-96E Service Manual

SERVICE MANUAL
MODEL : DVR-960S/T/H/D/E
TABLE OF CONTENTS
1. SAFETY & PRECAUTION 1-1. REMEMBER-SAFETY FIRST 4 1-2. WORKING WITH CHIP COMPONENTS 5
3. SET BLOCK DIAGRAM 11
4. SCHEMATICS 4-1. DVR-960S FRONT 12 4-2. DVR-960T FRONT 13 4-3. DVR-960H FRONT 14 4-4. DVR-960D FRONT 15 4-5. DVR-960E FRONT 16 4-6. Power, Reset, Audio, HDMI 4-7. TVP5146, 1394PHY, USB 4-8. Flash, ATAPI 4-9. DDR SDRAM & TERMINATION 4-10. DMN-8652 4-11. A/V Output 4-12. A/V Input, Tuner 4-13. SCART 4-14. SMPS
17 18 19 20 21 22 23 24 25
5. PCB DIAGRAMS
5-1. DVR-960S FRONT PCB 26 5-2. DVR-960T FRONT PCB 27 5-3. DVR-960H FRONT PCB 28 5-4. DVR-960D FRONT PCB 29 5-5. DVR-960D SLIDE FRONT PCB 30 5-6. DVR-960E FRONT PCB 31 5-7. MAIN PCB_TOP 32 5-8. MAIN PCB_BOTTOM 33 5-9. SCART PCB 34 5-10. SMPS 35
6. ELECTRICAL PART LIST 36
7. TROUBLE SHOOTING
7-1. Initial Troubleshooting 40 7-2. DVD Mode Video Troubleshooting 4 7-3. DVD Mode Audio Troubleshooting 4 7-4. Tuner INPUT mode Troubleshooting 4 7-5. AV INPUT mode Troubleshootin 4 7-6. DV INPUT mode Troubleshootin 43
0 1 2 3
7-7. USB INPUT mode Troubleshootin 43 7-8. DVD/HDD REC Mode VIDEO Troubleshooting 4 7-9. DVD/HDD REC Mode AUDIO Troubleshooting 4 7-10. CANAL FUNCTION 4 7-11. Firmware Up-grade 4
4 5 6 6

1. SAFETY & PRECAUTION

1-1. REMEMBER-SAFETY FIRST

WARNING : Always disconnect the unit from the mains supply before dismantling it.
WARNING : Remove your wrist strap before applying power to the reassembled.
equipment to avoid potential shock hazards.
WARNING : The incorrect substitution of electrolytic capacitors may result
in an explosion hazard.
CAUTION : Work on an earth mat and wear a wrist strap and earth lead to prevent
electrostatic damage to components. Once the main board is removed from the casing it is fairly flexible, so handle it carefully to avoid damaging the components.
CAUTION : Before you apply mains power to the unit , always ensure
that the voltage rating stated on the rear panel of the unit matches the mains voltage supply in the country of installation.
CAUTION : Do not spray chemicals on or near the unit.
CAUTION : Replacements for faulty components must be of the correct value
and rating and must be assembled by a competent service engineer, otherwise safety approvals could be invalidated.
CAUTION : Do not put anything on the top cover and beside of unit for well ventilation.
CAUTION : Do not overload wall outlets, extension cords or convenience receptacles
beyond their capacity, since this can result in fire or electric shock.
CAUTION : Never push objects of any kind into the set through the cabinet slots
as they may touch dangerous voltage point or short out part that could result in a fire or electric shock.
WORKING
RISK ELECTRIC SHOCK DO NOT OPEN
This symbol indicates dangerous voltage inside the product that presents a risk of electric shock
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER(OR BACK), NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
This symbol indicates Important instructions
!
Accompanying the Product.

1-2. WORKING WITH CHIP COMPONENTS

2. EXPLODED VIEW

2-1. DVR-960S

2-2. DVR-960T

2-3. DVR-960H

2-4. DVR-960D

2-5. DVR-960E

3. Block Diagram

SDA SCL
DVD PART(LSI LOGIC)
HDD
80/160 /2 5 0 GB
DVD+/- RW
DISPLAY FRONT
KEY,IR
IEEE1394 PHY I/F (TSB41AB1) U24
IEEE1394
USB
DATA[0:15]
DATA[0:15]
CLK, DATA, STB
DATA[0:7]
49MHz
256Mb X 2(DDR) U29, U30
HOST [MASTER] PORT
DVD DECODER (DMN8652) U32
FLASH 4 MB U28
I2C
E2PROM
(OPTION)
HDMI (OPTION)
HSYNC,VSYNC,MCLK
MCLK,BCK LRCK , AudioDATA[0:3]
I2C
16bit YPbPr
I2C
VO_D [1 5 ..0] AO_IEC958
2CH AUDIO DAC (PCM1754)
U16
Scaler
16bit YPbPr
HSYNC,VSYNC,MCLK
2M*32Bit SDR AM
VIDEO DRIVER
(MM1623) UA4
HDMI TRANSFER (SIL9030) U19
TTL UA5
OP AMP UA6
VIDEO SWITCH (MM1226) US4
VIDEO SWITCH (MM1228) US3
TXD+-[0:3]/TXC+-
CVBS/Y/C/R/G/B
OPTICAL/COAXIAL
AUDIO SWITCH (HEF4052B) US2
AUDIO SWITCH (HEF4052B) US1
DDC_I2C
FL/FR
HDMI OUT
L/R INPUT
L/R O UTPUT
CVBS OUTPU T CVBS INPUT
L/R INPUT
L/R O UTPUT RGB INPUT
CVBS INPUT CVBS OUTPU T
Y/C OUT
CVBS
2CH AUDIO OUTPUT
R/G/B OUT
JS1
SCART 1
JS2
SCART 2
8 BIT VIDEO O U T [CCIR656]
NTSC/PAL VIDEO DECODER (TVP5146) U25
MCLK,BCK LRCK ,D ATA[0:3]
RGB Y/C
CVBS
CVBS
AUDIO ADC (PCM1801)
U22
VIDEO SWITCH
(MM1111) UA2
AUDIO SWITCH (HEF4052B) UA1
AUDIO DEMOD
I2C
(MSP3415/25) UA3
I2C
L/R FRONT INPUT
L/R REAR INPUT
Y/C REAR INPUT
CVBS FRONT INPUT
CVBS REAR INPUT
V IDEO OUT AUDIO O U T
I2C
TUNE R TA1

4. SCHEMATICS

4-1. DVR-960S FRONT

4-2. DVR-960T FRONT

4-3. DVR-960H FRONT

4-4. DVR-960D FRONT

Loading...
+ 34 hidden pages