Vita Grande Trellis ASSEMBLY INSTRUCTIONS

ASSEMBLY INSTRUCTIONS
The Grande Trellis / Concord Trellis
87.38 in
(222 cm)
7 in (17.8 cm)
47 in
(119 cm)
Please read through before starting assembly.
IMPORTANT: CHECK THE INSIDE OF YOUR POSTS FOR ALL MATERIALS.
Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 5:00 PM EST).
1.
Arched T op Rail
2.Post Caps (2) 10611 White / 14085 Composite
3.Posts (2) Length - 94 ( 238.7 cm) - 10865 White / 14086 Composite
4.
Vertical Spindles
5.
Vertical Spindles
6.
Vertical Spindles
7.
Vertical Spindle
8.
Horizontal Spindles (5)
9.
Bottom Rail
10.
Ground Mounting Extensions
11.
3/4(19 mm) Self-Auguring Stainless Steel Screw
(1) - 10864 White / 14084 Composite
(2) Length - 83” (211 cm) - 10866 White / 14087 Composite (2) Length- 84 3/4” (215 cm) - 10866-2 White / 14087-2 Composite (2) Length - 86 1/2” (220 cm) - 10866-3 White / 14087-3 Composite
(1) Length - 87 1/4” (222 cm) - 10866-4 White / 14087-4 Composite
Length - 53 3/4“ (137 cm) - 10867 White / 14088 Composite
(1) Length - 53 3/4“ (137 cm) - 10868 White / 14089 Composite
(2) Length 30” (76 cm) - 10869 White / 14090 Composite
(25) 20016 White / 20025 Composite
Tools You Will Need
• Cordless Drill
• Hammer
• Tape Measure
• Level
• Shovel
10
General Information
Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 5’x 8’ (1.5 m x 2.4 m) for unobstructed assembling.
• You should not need to use excessive force when
assembling component.
54 in
(137 cm)
11
Not to Scale
1 2
3
4
5
6
7
8
9
www.wearevita.com
96 in
(244 cm)
2 in
(5 cm)
V3.5/01/06/2021
1
STEP ONE
NOTE: There are locking tabs located at the ends of the horizontal rails. Once inserted and pushed into the routed holes, they will lock into place.
1
Lay one of the posts on the ground and insert the bottom
rail and the five horizontal rails as shown aside.
Note the holesorientation and ensure that they all face
the same direction as shown in drawing aside.
2
Insert the seven vertical spindles as shown aside.
Please note that there are four different lengths of
spindles and they should be inserted according to the
pattern shown (spindles are labeled accordingly).
3
Continue assembly by inserting the top arched rail end
into the post and progressively into each of the vertical
spindles.
4
Proceed to attach the second post to the trellis assembly
as shown below. Ensure tabs are inserted all the way into
the posts.
1
1
2
2
3
4
3
2
1
5
Install the post caps.
Insert 1st
3
5
4
2
he Grande /
T
Concord Trellis
www.edenarbors.com
STEP T WO
Install the Screws
While making sure the trellis is square, secure the trellis with 21 of
the provided screws at the locations shown below:
The Grande / Concord
Trellis
3
Mounting Into the Ground
Trellises must be well secured in the event of high winds, etc. We have provided two ground mounting extensions for securing the trellis
either into the ground or into a concrete footing. If you are wood deck appropriate galvanized bracket hardware.
installing your trellis directly to the wall of your home, or on a
or concrete surface, please see your hardware store for the
STEP THREE
Install t he Ground Mounting Extensions
Insert the ground mounting extensions into the bottom of the
trellis
posts. Secure with screws as shown aside.
STEP FOUR
Install Tre llis into Ground
3
A
Move the trellis to its final location. When you are satisfied with
the location, mark the positions of the posts, then move the trellis
aside and lay it carefully on its side. Excavate the 2 post holes
approximately 22" (56 cm) deep x 6" (15 cm) diameter.
Carefully move the trellis
back into position.
B
Level it both vertically and horizontally into the excavated holes.
C
Backfill the holes with the excavated soil.
Note: For a stronger installation, consider purchasing pressure
treated 2"x4" (5 cm x 10 cm) lumber and trimming it down to
3 1/4 (8 cm) wide and cutting it into 36” (91 cm) lengths.
Insert into the bottom of the posts until they hit the bottom
horizontal rail. Fasten accordingly with screws and install either directly into the ground or into a concrete footing.
4
4
B
Level
A
22” (56 cm)
6“
(15 cm)
4
North America Toll Free Phone: 1 800 282 9346
C
www.wearevita.com
Loading...