Visual Sound SON OF HYDE, Visual Volume, Workhorse Stallion 60w 212, Workhorse Pony 30w 112, Angry Fuzz Instruction Manual
...
4922 Port Royal Road B-11 6 Spring Hill, Tennessee 37174 6 931-487-9001
www.visualsound.net 6 www.myspace.com/visualsoundusa
Bob Weil and R.G. Keen worked hard to design this pedal for you, using their ears and engineering skill to produce the best
effects possible. They also tested the pedals during the design phase with many great guitarists to get their opinions on tone
and features. What resulted is the pedal you’re holding right now. Not only will you love the sound of your new pedal, but you
can rely on it to last for many years to come.
The new switching system in the V2 Series is designed to last for 10 million foot-stomps...yes, that’s basically forever! All the
jacks including the power jack are hand-wired, point-to-point, to the circuit board so if you accidentally step on a plug, it will
keep on working. Even if you plug in a 9VAC power supply by mistake, it won’t burn up your pedal as would happen in most
other effects...it won’t work, but it won’t do any damage. As always, Visual Sound effects pedals can take a variety of
musician rated 9VDC adapters*, including of course the 1 SPOT
®
power supply made by Visual Sound.
You will also benefit from the Pure Tone buffer circuit used in all Visual Sound effects pedals since 1997. The Pure Tone
circuit is a unity gain pre-amp buffer designed to make your guitar sound like it’s plugged directly into the amp even if it’s
going through long cables and many other effects pedals...something “true-bypass” pedals could never give you.
Use this instruction manual as a guide for getting started with great tones from your new V2 Series pedal. Of course,
you should experiment with your own settings as well...there are no rules when it comes to discovering your own sound.
Just find the tones that inspire you to play. That’s what it’s all about!
*Boss, Ibanez, Dunlop, Morley, Voodoo Labs and other musician rated 9VDC power supplies will also work (output plug with center pin negative)...do not use Radio Shack or other non-musician
power supplies. Shameless promotional plug: The 1 SPOT is the best 9VDC power supply for all your pedals!
First launched in 1997, Jekyll & Hyde was the first pedal to combine two
separate effects in one package. The new
V2 Series
Jekyll & Hyde gives
the same great tone guitarists have come to love over the years, but
with all the advantages of V2construction plus an added noise
reduction system.
Each channel has separate controls, but with the ability to use them
individually or together. The Jekyll overdrive channel is designed
to accurately reproduce the sound of the TS-808 Tubescreamer,
but with a
Bass Boost
switch and far more output volume
than the original. Hyde is a heavier distortion with more
bottom end and is extremely versatile. Not just a “Turbo”
version of Jekyll, Hyde has a wide range of sounds that can
be discovered by using the
Mid
knob to adjust the midrange,
a
Sharp/Blunt
switch to go from a more compressed distortion
to very bright, along with
Drive, Treble
, and
Volume
knobs to set
the overall style of sound. With the user-friendly controls, the sonic
possibilities are endless. On the following pages are some settings to
get you started...
JEKYLL SETTINGS JEKYLL SETTINGS
NOTE: UNLESS OTHERWISE SHOWN, ‘BASS BOOST’ IS IN ‘OFF’ POSITION.
HARD CRISP CRUNCH MELLOW BLUES SLIGHTLY SOILED BOOST
BROKEN UP JAZZ
HYDE SETTINGS HYDE SETTINGS
CLASSIC
HARD ROCK
METAL
MADNESS
ZZ DISTORTION
BIG FAT
BLUES
BRITISH
STACK
BUZZ BOMB
SOUTHERN
ROCK
NECK PICKUP
BLUES
COMBINATION SETTINGS COMBINATION SETTINGS
NOTE: USING ‘JEKYLL’ & ‘HYDE’ WITH BOTH ‘DRIVE’ KNOBS ALL THE WAY UP MAY CAUSE FEEDBACK.
THICK FUZZ
FOR EVEN BETTER RESULTS,
COMBINE WITH ROUTE 66 COMPRESSOR.
PURE POWER
METAL SOLO BOOST
HOT BLUES
CIRCUIT BOARD ADJUSTMENTS
Use these internal circuit board controls to create and fine tune
your individual sound!
A BASS CONTROL:
For Distortion Channel. Factory setting at maximum.
Turn counter-clockwise for reduced bass response.
B NOISE REDUCTION ON/OFF SWITCH:
For Distortion Channel. Switch Right to turn ‘OFF’, switch Left to turn ‘ON’.
C NOISE REDUCTION LEVEL: Factory setting at minimum.
Turn clockwise for increased noise reduction.
H2O
Normal/Lush switch added on Chorus
channel. Same great chorus and echo
tones that H2O is famous for
..
JEKYLL & HYDE
New noise reduction and improved Mid control on Hyde
channel. Additional low-drive range on Jekyll channel.
Same great overdrive and distortion tones that
Jekyll & Hyde is famous for.
DOUBLE TROUBLE
Visual Sound’s interpretation of the TS-808
(with bass boost and lots more volume),
times 2! Use either overdrive by itself or
combine them.
ROUTE 66
New noise reduction on Compressor channel.
Additional low-drive range on overdrive channel.
Same great compression and overdrive tones
that Route 66 is famous for.
COMP 66
The compressor channel of the new Route 66
in a single pedal.
SON OF HYDE
The Hyde distortion channel from the new
Jekyll & Hyde in a single pedal.
ROUTE 808
One channel of Double Trouble in a single pedal...
Visual Sound’s interpretation of the TS-808 (with bass
boost and lots more volume).
LIQUID CHORUS
The chorus channel of the new H2O in a single pedal,
with an added Depth knob. Also has 2 outputs, normal and
inverted, for running in stereo.
ANGRY FUZZ
A brand new effect unlike any fuzz pedal you’ve ever heard. Blend in an
octave up with the Anger Level knob and get crazy low octave overtones to
boot! Octave tracking is flawless even with the fastest shredding imaginable.
Originally released in 1995 and now
back by popular demand, the new Visual
Volume 10th Anniversary Edition is the
finest, most useful volume pedal
ever created. Don’t just try to
find the right volume by ear, see it with
the 0-10 LED readout!
; All new
design with
die-cast aluminum
housing and blue
LEDs!
; Active and
Passive modes
; Clean boost pre-amp
in Active mode
; Two inputs and
outputs for mono
or stereo use
; Tuner Out jack for
silent tuning
EXCELLENT
FOR LIVE PLAYING
SITUATIONS!
PONY
30w 112
STALLION
60w 212
The Hubcap is a carefully designed,
patent pending, sound dispersion speaker
grill that disperses almost 180 degrees
worth of quality, full range sound.
There are many amps with multiple channels, but few sound good on every channel and even fewer sound good with
effects pedals. Finally, Visual Sound has designed a series of amps with just one great clean tube channel...
perfect for effects pedals. And just to prove our point, we’ll give you our #1 selling pedal, the Jekyll & Hyde,
absolutely FREE! That gives you a total of four great sounding channels!
; Revolutionary easy user-biasing on all models! 6L6 tubes(stock)
or switch to EL34 or similar without paying an amp tech
; Volume, Bass, Mid, Treble, & Reverb controls...5 knobs...simple!
; 9VDC output & cable for powering effects pedals
; Protection circuitry throughout the amplifier to
prevent failure of all critical components
; Celestion speakers in an all wood cabinet
; Hand wired controls and jacks
; Toroidal power transformer
FREE! JEKYLL & HYDE
ULTIMATE OVERDRIVE
PEDAL PLUS PADDED
COVER with POCKETS!
Pedal boards are for pedals...not power supplies.
Bigger is not always better. At a fraction of the cost, the 1 SPOT®is more powerful than
the PedalPower
**
or DC Brick**...and takes up NO space on your pedal board!
Frustrated with powering only two or three effects pedals with a 6-outlet power strip?
Visual Sound has created the perfect alternative to awkward transformer-type adapters. The 1 SPOT
®
9VDC regulated power supply will work with virtually any pedal on the market today. It can even
power many keyboards and other musical equipment. The 1 SPOT
®
features worldwide 100v-240v
input voltage allowing it to be used anywhere in the world! With 1700mA Output Power, the 1 SPOT
®
can power all of your pedals from a single outlet*with the use of Multi-Plug cables.
1SPOT® Combo
Pack Includes:
1SPOT
®
Power
Supply PLUS (1) MC8
Multi-Plug Cable, (2)
CBAT Battery Clip
Converters, (2) C35
3.5mm Converters,
and (1) L6 Line 6
Converter
Unlike most companies, Visual Sound puts a lot of thought into cheap accessories.
Believe it or not, the Multi-Plug 5 and 8 Cables are the only “daisy chain” cables featuring right angle plugs
and over 12” (300mm) between each plug. We even designed spring-loaded input socket contacts so your
MC5, MC8, or converter won’t unplug unless you want it to.
3.5mm Converter (C35)
Allows the 1 SPOT®adapter
and Multi-Plug Cable to be used
with any 9VDC pedal
*
with
a 3.5mm (1/8”) power jack
(E-H
**
, old MXR**, etc.)
L6 Converter (CL6)
Allows the 1 SPOT®adapter &
Multi-Plug Cable to be used with
Line 6
**
modeling pedals &
Digitech
**
RP100
Battery Clip Converter
(CBAT)
Allows the 1 SPOT®adapter &
Multi-Plug Cable to be used with
9V guitar pedals
*
that only have
a battery connection
Reverse Polarity
Converter (CYR)
Allows the 1 SPOT®adapter
to be used withYamaha
*
keyboards, samplers, and
drum machines
MULTI-PLUG 5 CABLE
(MC5)
Allows connection of up
to 5 units to the 1 SPOT
®
adapter...Connect cables
together to power even
more units
*
*Up to power rating of the
1 SPOT¤Adapter
MULTI-PLUG 8 CABLE
(MC8)
Allows connection of up
to 8 units to the 1 SPOT
®
adapter...Connect cables
together to power even
more units
*
*Up to power rating of the
1 SPOT¤Adapter
**Brand names listed are trademarks of their respective companies and have no affiliation with Visual Sound.
Loading...