Visual Sound Liquid Chorus User Manual

Liquid Chorus

Intern

al

Control

:

Version 05/2010

One of the great things about the new V2 Series of pedals is that you can now get your
favorite Visual Sound effects in single effect pedals… something that has long been
requested by musicians. Liquid Chorus is a wonderfully voiced effect for electric,
acoustic, or bass guitar, using pure analog circuitry. Use the Depth knob to set the
overall style of Chorus (from light to lush) and the user-friendly knobs for the settings.
Unlike H2O, the second output of Liquid Chorus is a true stereo output for extremely
spacious sounds when used with two amps or a PA system.

Following are some settings to get you started:

Output 2 Dry or Stereo
Switch: Factory setting
is Stereo. Switch to
Dry for non-effected
output on Output 2.
Output 1 is always
effected.

Power with either a 9V alkaline battery or 9VDC regulated power supply like the 1 SPOT.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:!
!
— Reorient or relocate the receiving antenna.!
— Increase the separation between the equipment and receiver.!
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.!
— Consult the dealer or an experienced radio/TV technician for help.