Visteon BLUE11M User Manual

Re: Certification for JCI Bluetooth Transceiver

Model/PN(s): CB2-BLUE11M

FCC ID: NT8-BLUE11M
IC:3043A-BLUE11M

The device under test is manufactured by the grantee (Visteon Corporation) and sold as
an OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the
end-user has all applicable / appropriate operating instructions.

When end-user instructions are required, as in the case with this product, the grantee must notify the
OEM to notify the end-user.

Visteon Corporation will supply the following information to the reseller/distributor dictating
what must be included in the end user’s manual for the commercial product:

INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL

The following information must be included in the end product user’s manual to ensure continued
FCC and Industry Canada regulatory compliance.

************************************************************************

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

Changes or modifications not expressively approved by the party responsible for compliance could void
the user's authority to operate the equipment.

This device complies with Industry Canada Standard RSS-247. Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference that may cause undesired operation of the device.

************************************************************************

It is preferred that the following ID numbers be included in the manual if the device label is not
readily accessible to the end user.

************************************************************************

FCC ID:NT8-BLUE11M

**********

**************************************************************

IC: 3043A-BLUE11M

The following information should be provided to the end user, regardless of placement of the
device (portable vs. installed in vehicle), by citation in the manual. Please note that co-location is
generally considered to be when 2 transmitters radiating elements are < 20 cm apart from each
other.

************************************************************************

The antenna used for this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. End-users and installers must be provided with installation instructions and
transmitter operating conditions for satisfying RF exposure compliance.