Visteon 13NDC1-5 FCC statment

Visteon Corporation
Suite: 25.2.025
One Village Center Drive
Van Buren Township, MI 48111

Tel: [phone]
Fax: [phone]
Email: [e-mail]

S

ee the possibilities

cember 4, 2012

De



Terry SanSouci

Product Assurance Engineer
Electronics Product Group

Re: Users Manual Declaration Statements

Model Name: VBTDC1.5
FCC ID: NT8-13NDC1-5
IC: 3043A-13NDC15

To Whom It May Concern:

The product integrator of the model name above must place the following compliance statements
on their end product label and in a prominent location in their users manual for the North
American Market.

FCC & IC statements (§ 15.19 Labelling Requirements)

This device complies with part 15 of the FCC and Industry Canada Rules.
Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.

The FCC statement listed below (§ 15.21 Information to the User) shall also be placed in a
prominent location in the end product integrator’s user manual under relevant title “CAUTION

TO USERS” or “FCC WARNING” or “NOTE”

Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

Page 1 of 2

Visteon Corporation
Suite: 25.2.025
One Village Center Drive
Van Buren Township, MI 48111

Tel: [phone]
Fax: [phone]
Email: [e-mail]

S

ee the possibilities

cember 4, 2012

De



Terry SanSouci

Product Assurance Engineer
Electronics Product Group

Re: Users Manual Declaration Statements

Additionally, the ID numbers for the model name above must be included on the end product
integrator’s label and in their users manual as follows.

“Contains FCC ID: NT8-13NDC1-5”
“Contains IC: 3043A-13NDC15”

If you have any questions, please feel free to contact me at the address shown above.

Thank you for your attention to this matter.

T

erry SanSouci
Visteon Corporation
Product Assurance Engineer
December 4, 2012

Page 2 of 2