Vista Imaging VFSM15 User Manual

USER

Vista 15” TFT LCD MONITOR

MANUAL

MODEL: VFSM15

Table of Contents

● FCC Information - 2

● Safety Precautions - 2

1. General Features - 4

2. Setting Up - 5

3. Controls and Indicators - 6

4. On Screen Display - 8

5. Specifications - 12

1

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different form that to which

the receiver is connected.

- Consult the dealer or an experienced radio/ TV technician for help.

Shielded interface cables and AC power cord, if any, must be used in order

to comply with emission limits.

Changes or modifications not expressly approved by the party responsible

for compliance could void the user‘s authority to operate the equipment.

SAFETY PRECAUTIONS

1. Do not modify the three-prong grounding type monitor power plug in any way.

2. Operate this unit only from the type of power source indicated on the label.

3. Do not block or cover ventilation openings on the back or bottom of the

monitor cabinet.

4. Do not place this monitor near a radiator or heating vent.

5. Do not push objects of any kind through cabinet openings. This may result in

fire or electrical shock.

6. Before adding attachments always ask a service technician to perform

routine safety tests to determine that equipment is in safe operating

condition. Ground potential tests should be part of the routine safety check

made by the service technician.

7. Do not place monitor on an unstable cart, stand, or shelf where it may fall

and injure personnel or damage equipment.

2

8. Route power cords so that they cannot be walked upon or tripped over. Do

not allow anything to rest on the power cord.

9. Do not install monitor in wet areas, or where it may be exposed to rain or

water. Do not spill liquid of any kind on the unit.

10. Unplug the power cord from the unit before cleaning the display. Use only

a damp cloth. Do not use alcohol, spirits, or ammonia to clean the display.

DO NOT ATTEMPT TO CLEAN THE INTERIOR OF THIS UNIT-THIS ACTION

MUST BE PERFORMED BY THE SERVICE TECHNICIAN AS REQUIRED

DURING NORMAL MAINTENANCE.

11. Refer all servicing to qualified service personnel. REMOVAL OF BACK

COVER BY UNAUTHORIZED PERSONNEL MAY EXPOSE THE USER TO

DANGEROUS VOLTAGES OR OTHER HAZARDS.

12. Unplug the unit immediately and notify the service technician.

A. If liquid has been spilled into the display or the display has been

exposed to rain or water.

B. If the unit has been dropped or the cabinet damaged.

C. If fuses continue to blow.

D. If the power cord is damaged or frayed.

E. If a distinct change from normal operation is apparent.

When replacement parts are required, be sure that the service technician

uses components specified by the manufacturer which have the same

characteristics as the original parts. UNAUTHORIZED SUBSTITUTIONS MAY

RESULT IN FIRE, ELECTRICAL SHOCK OR OTHER HAZARDS.

Upon completion of any service or repairs, ask the technician to perform

safety checks to determine that the equipment is in safe operating condition.

WARNING: SERIOUS SHOCK HAZARDS EXIST WITHIN THE COVERS OF

THIS MONITOR. DO NOT OPEN THE COVERS UNDER ANY CIRCUMSTANCES,

THERE ARE NO USER SERVICEABLE COMPONENTS INSIDE

3

1.GENERAL FEATURES

This is a high performance 15" TFT LCD monitor with a 1024x768 XGA resolution. The LCD monitor
has been designed for use with both PC and security systems, comply with the power management
regulations of VESA DPMS, supported by Plug & Play, complying with DDC1/2B.

FEATURES

90~264V AC Power Supply

NTSC/PAL Auto-Detector

High Resolution

PC Input

Dual Video Input/Output

Dual Audio Input/Output

Y/C Input

Up to 16M Colors

Built-in Auto Channel Scanning

OSD With Multiple Languages

Wall Mountable

4