Vista VLFSM15D_h, VLFSM17D_h, VLFSM19D_h User Manual

USER’S
MANUAL

VISTA 15”/17"/19” TFT LCD MONITOR

MODEL: VLFSM15D/17D/19Dh Series

1

Table of Contents

● FCC Information - 2

● CE Information - 2

● Safety Precautions - 3

1. General Features - 4

2. Setting Up - 5

3. Controls and Indicators - 6

4. On Screen Display - 8

1

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.

However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

- Consult the dealer or an experienced radio/TV technician for help.

- Shielded interface cables and A.C. power cord, if any, must be used in order to comply with

emission limits.

Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

CE INFORMATION

The product must be installed according to the currently valid installation regulations for
EMC to guarantee the designed use and to prevent EMC problems.

The device supplied with this manual is according to the EC, EMC Directive, 89/336/EEC &
LVD 73/23/EEC

Standard used for showing compliance with the essential requirements of the device:
EN 55022
EN 61000-3-2
EN 61000-3-3
EN 50130-4
EN 55024
LVD: EN 60950-1

2

SAFETY PRECAUTIONS

1. Do not modify the three-prong grounding type monitor power plug in any way.

2. Operate this unit only from the type of power source indicated on the label.

3. Do not block or cover ventilation openings on the back or bottom of the monitor cabinet.

4. Do not place this monitor near a radiator or heating vent.

5. Do not push objects of any kind through cabinet openings. This may result in fire or

electrical shock.

6. Before adding attachments always ask a service technician to perform routine safety

tests to determine that equipment is in safe operating condition. Ground potential tests
should be part of the routine safety check made by the service technician.

7. Do not place monitor on an unstable cart, stand, or shelf where it may fall and injure

personnel or damage equipment.

8. Route power cords so that they cannot be walked upon or tripped over. Do not allow

anything to rest on the power cord.

9. Do not install monitor in wet areas, or where it may be exposed to rain or water. Do not

spill liquid of any kind on the unit.

10. Unplug the power cord from the unit before cleaning the display. Use only

a damp cloth. Do not use alcohol, spirits, or ammonia to clean the display.
DO NOT ATTEMPT TO CLEAN THE INTERIOR OF THIS UNIT- THIS ACTION
MUST BE PERFORMED BY THE SERVICE TECHNICIAN AS REQUIRED
DURING NORMAL MAINTENANCE.

11. Refer all servicing to qualified service personnel. REMOVAL OF BACK

COVER BY UNAUTHORIZED PERSONNEL MAY EXPOSE THE USER TO
DANGEROUS VOLTAGES OR OTHER HAZARDS.

12. Unplug the unit immediately and notify the service technician.

A. If liquid has been spilled into the display or the display has been

exposed to rain or water.
B. If the unit has been dropped or the cabinet damaged.
C. If fuses continue to blow.
D. If the power cord is damaged or frayed.
E. If a distinct change from normal operation is apparent.

When replacement parts are required, be sure that the service technician uses components
specified by the manufacturer which have the same characteristics as the original parts.
UNAUTHORIZED SUBSTITUTIONS MAY RESULT IN FIRE, ELECTRICAL SHOCK OR
OTHER HAZARDS.

Upon completion of any service or repairs, ask the technician to perform safety checks to
determine that the equipment is in safe operating condition.

WARNING: SERIOUS SHOCK HAZARDS EXIST WITHIN THE COVERS OF THIS
MONITOR. DO NOT OPEN THE COVERS UNDER ANY CIRCUMSTANCES,
THERE ARE NO USER SERVICEABLE COMPONENTS INSIDE

3