Vista 4017 Installation Instructions Manual

Housing

4017

Landscape Series

Specialty Lights

INSTALLATION INSTRUCTIONS

IF USING AN LED LAMP - USE ONLY ON 9 - 15 VOLT CIRCUITS. CAUTION: DO NOT UNNECESSARILY OVER-VOLTAGE LED LAMPS. FOR
OPTIMAL PERFORMANCE AND MAXIMUM EFFICIENCY ALWAYS OPERATE LED LAMPS AS CLOSE TO 12 VOLTS AS POSSIBLE. NEVER EXCEED
MAXIMUM OPERATING VOLTAGE, FAILURE TO DO SO WILL VOID THE WARRANTY AND MAY RESULT IN SERIOUS DAMAGE TO LAMP AND
LUMINAIRES. DIMMING FUNCTION MAY NOT BE COMPATIBLE WITH ALL DIMMERS, PLEASE CONSULT FACTORY TECHNICAL DEPARTMENT
FOR UP-TO-DATE COMPATIBLE DIMMER INFORMATION.

FOR USE ONLY WITH LOW VOLTAGE LANDSCAPE POWER UNITS THAT DO NOT EXCEED 25 AMPS, 15 VOLT MAXIMUM.
WARNING: Luminaires must be installed in accordance with the National Electrical Code (NEC) and local codes. Failure to do so will void the warranty

and may result in serious injury and/or damage to the luminaire.
SAFETY WARNING: Luminaire can become very hot depending on lamp wattage used. Lens and metal around lamp can become hot enough to blister
hands. Particular care should be taken not to locate luminaires where small children can reach them if high wattage lamps are used.

LUMINAIRES ARE NOT TO BE INSTALLED WITHIN 10 FT. (3.05M) OF A POOL OR SPA. SECONDARY CABLE IS NOT TO BE BURIED MORE
THAN 6”. WHEN USING MULTIPLE LUMINAIRES, LOAD IS NOT TO EXCEED THE TOTAL WATTS OF TRANSFORMER RATING. DO NOT USE
EXTENSION CORDS ON POWER UNITS.
NOTE: Always use UL recognized wire connectors for connections.

LUMINAIRE MOUNTING:

1. To prevent electrical shock, disconnect transformer from electrical supply
before installation or service.

2. Using the mounting base as a template, mark the mounting hole
positions.

3. Use appropriate anchoring screws (by others) to mount the base to the
mounting surface.

4. Strip the two (2) leads from the luminaire pigtail. Using the two (2) safety
connectors (provided), connect the leads from the luminaire to the main
supply cable leads.

NOTE: Luminaires are supplied with 36” of 18-2 cable pigtail for secure
connection to the main supply cable. The wire is to be protected by routing
in close proximity to the luminaire.

5. 5. Provide power to the luminaire and check for proper operation.

NOTE: Avoid aiming fixture directly upward. Whenever possible, set at
angle to prevent rain or irrigation water from settling on lens.

WARNING - TO REDUCE THE RISK OF FIRE, OR INJURY TO PERSONS:

1. Turn off/unplug and allow to cool before replacing lamp.

2. Lamps get hot! Contact only switch/plug when turning on.

LAMP INSTALLATION/REPLACEMENT:

IMPORTANT SAFETY INSTRUCTIONS - THE LIGHTED LAMP IS HOT!

SAVE THESE INSTRUCTIONS (Leave with property owner/manager)

Flexible Stem

Stem

Mounting Base

3. Do not touch hot lens, guard or enclosure.

4. Keep lamp away from material that may burn.

6. Do not operate luminaire fitting with a missing or damaged cover.

CAUTION: Do not exceed maximum wattage marked on luminaire label.

1. To prevent electrical shock, disconnect transformer from electrical supply

before service.

2. Remove shroud to expose lamp.

3. Replace lamp with correct wattage and type marked on fixture label.

NOTE: DO NOT touch lamp with bare hands. Always use soft cloth or the
plastic wrapping (if available) from lamp to handle the lamp.

4. Re-install shroud.

Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification.

1625 Surveyor Avenue • Simi Valley, CA 93063 • [phone] • (800) 766-VISTA (8478)

FAX: (888) 670-VISTA (8478) • [e-mail] • www.vistapro.com

4017 10.13

INSTALLATION INSTRUCTIONS

MOUNTING TEMPLATE:

When printing, page scaling should be set as “none.”

4017

Landscape Series

Specialty Lights

.2”

2 PLACES

3½”

Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification.

1625 Surveyor Avenue • Simi Valley, CA 93063 • [phone] • (800) 766-VISTA (8478)

FAX: (888) 670-VISTA (8478) • [e-mail] • www.vistapro.com

4017 10.13