Vision X XMITTER Series Installation Instructions & User Manual

Installation Instructions & User’s Manual

www.VISIONXUSA.com

VISION X XMITTER

About the XMITTER:

FEATURES

1. Original Light Bar with Seamless Beam

2. Used by NASA, Border Patrol, Pro Racers

3. Infrared, Amber, Red, Blue, and Green Available

XMITTER SERIES SPECIFICATIONS

1

4

LED Light Bar

MOUNTING

Allen Key

PART (M5)

(5mm)

Qty: 1

Qty: 1

2

One Light

Harness

WIRING PART (M1)

Qty: 1

Mounting Foot

3

QTY

Varies

1. Warranty : Extended

2. Amp Draw : 1A - 25A (@12V)

3. Input Voltage : 9-42V

4. Beam Patterns : Euro, Flood

5. LED Lifespan : 50,000 Hours

PREPARATION

1. We recommend completely reading instructions before installing.

2. Consult your local state regulatory agency regarding the use of LED
lighting.

3. The placement of LED lighting should not restrict airow to the radiator, or
block head lamps, turn signals, or parking lights.

MAINTENANCE

1. All Vision X models have been designed for maintenance free use. In the
case an LED lamp or other part replacement is needed please contact
your authorized service center.

MOUNTING FEET BY NUMBER OF LEDS

4LED 8LED 12LED 20LED 32LED 40LED 60LED 80LED 100LED

# of

Feet

WARNINGS

1. Don’t stare directly into the light or shine directly into the eyes of another
person as this may cause temporary loss of vision.

2. Never disassemble the products, as all parts must be factory serviced to
insure proper operation.

3. After turning on the light, the body might be hot enough to warrant a burn
risk. Be careful when you touch the body after turning on the light for a long
period of time.

4. Use the supplied wire harness for electrical installation.

5. The LED light must not adversely affect the performance of low beam, high
beam, engine cooling or the driver’s view.

1 2 2 2 3 3 4 4 6