VisionX VX Series Installation Instructions & User Manual
VISIONXLIGHTING.COM
Installation Instructions & User’s Manual
VISION X
About The VX SERIES 7” HEADLIGHT
FEATURES
1. LED Halo
2. DOT approved
3. Multiple wiring connections available
VX SERIES 7” HEADLIGHT SPECIFICATIONS
1. Warranty : Extended
2. Amp Draw : High 3.0A/ Low 2.2A/ Halo 0.33A @12V
3. Input Voltage : 9-32V
4. Beam Patterns : High, Low, Halo
5. LED Lifespan : 50,000 Hours
PREPARATION
1. We recommend completely reading instructions before
installing.
2. Consult your local state regulatory agency regarding the
use of LED lighting.
3. The placement of LED lighting should not restrict airow to
the radiator, or block head lamps, turn signals, or parking
lights.
MAINTENANCE
1. All Vision X models have been designed for
maintenance free use. In the case an LED lamp or other
part replacement is needed please contact your authorized
service center.
VX SERIES LED HEADLIGHT
1
Qty: 2
7” Headlight
XIL-7RD
WARNINGS
As with many other high-tech products, this VISION X LED
requires a bit of attention before you can use it. Please read
the accompanying information carefully rst.
1. Don’t stare directly into the light or shine directly into the
eyes of another person as this may cause temporary loss
of vision.
2. Never disassemble the products, as all parts must be
factory serviced to insure proper operation.
3. Don’t interchange the parts inside this light with other
products.
4. The LED light is to be mounted on the vehicle only in a
vertical, bottom mounting, or in a suspended position.
5. After turning on the light, the body might be hot enough
to warrant a burn risk. Be careful when you touch the
body after turning on the light for a long period of time.
6. Use the supplied wire harness for electrical installation.
7. The LED light must not adversely aect the performance
of low beam, high beam, engine cooling or the driver’s
view.
1
Qty: 2
7” Headlight
XIL-7RD
2
Qty: 2
H4 Plug
P-HLH42H13
XIL-7RDKITJK
XIL-7RDKIT
Loading...