Visionary Solutions AVN200, AVN210, AVN220 Quick Start Manual

Visionary Solutions, Inc.

AVN2XX Quick Start

Guide

(AVN200, AVN210, and AVN220)

AVN200 AVN220

©2009 Visionary Solutions, Inc. All rights reserved.

 Please visit the support section of our website at

AVN210

www.vsicam.com for manuals, other documentation, and software

downloads.

 This is a Quick Start Guide only and NOT the full User’s Manual.

Current user manuals are available online.

April, 2013
Revision: 1.0.3

2060 Alameda Padre Serra, Suite 100∙ Santa Barbara, CA 93103

Tel: [phone] ∙ Fax: [phone] www.vsicam.com

AVN2XX Quick Start Guide

2

AVN200
Front Panel
Diagram:

Introduction

This document is intended to assist users of the AVN2XX series encoders in the initial
configuration and setup of the devices. This document is NOT intended to provide
installation instructions for either the AmiNet or other AVN products (AVN4XX).

Requirements

In order to setup the AVN2XX for streaming, the user must have a valid video source, an
available network address, and some sort of decoder, either software or hardware.

Step 1: Connect AVN2XX Hardware

1. Connect one or more of your video sources to the appropriate video input(s).

2. Connect one or more of your audio sources to the appropriate audio input(s).

3. Connect the LAN Ethernet cable to the Ethernet RJ-45 connector.

4. Connect the power cable to the AVN2XX Power Supply connector and power on
the AVN2XX. In the case of the AVN220 (blade) the power is supplied via the
MPPXXX chassis.

Input Connector Diagrams by Device Type

2060 Alameda Padre Serra, Suite 100∙ Santa Barbara, CA 93103

Tel: [phone] ∙ Fax: [phone] www.vsicam.com

AVN2XX Quick Start Guide

3

AVN200
Rear Panel
Diagram:

AVN210 Front Panel Diagram:

AVN210 Back Panel Diagram:

AVN220 Panel Diagram:

2060 Alameda Padre Serra, Suite 100∙ Santa Barbara, CA 93103

Tel: [phone] ∙ Fax: [phone] www.vsicam.com