User manual
V Inground Series
VI-1TC VI-6 VI-12
V Inground is a high power and robust outdoor luminaries. With cutting edge LED technology, IP67 rated and
drive over resistant construction, the V Inground is specially designed for illuminating walkways and
landscape.
1. Attention:
- Do not install the fixture near high inflammable liquids or materials.
- Do not allow anything to rest on the fixture.
- Do not install the fixture near the naked flames.
- Do not install the fixture in dirty, dusty location.
- Do not looking directly into the LED light beam at close range.
- Operate only in places where the sufficient air flow is present.
2. Technical specifications:
Item
VI-1TC VI-6 VI-12
Max. Input Current 350mA 350mA 350mA
Input Voltage DC 48V DC 48V DC 48V
Power Consumption 3.3W 6.5W 13.1W
Compatible Power Supply V Power 60, V Power 120, V Power 240, V Power 600
LED Emitter 3W 1W 1W
Number of LEDs 1 x Tri-color 2R, 2G, 2B 4R, 4G, 4B
LED Life Expectancy 50,000hrs 50,000hrs 50,000hrs
Beam Angle 25°, 40° 15°, 25° 15°, 25°
Available LED Colors RGB(3 in1) RGB RGB
IP Rated IP 68 IP 67 IP 67
Power/Data Cable 1.5m, 24AWG x 4P Cat.5e Cable
Size
Ø45 x 82mm Ø119 x 131mm
Ø 181 x 97mm
Weight 0.4kg 0.8kg 2.0kg
3. Installation
The V Inground unit should be conne cted to the V Power driver. See V Power 60( or V Power 120, V Power
240, V Power 600) user manual for full details of mains power requirement, built-in programs and DMX
operation. Connect the end of the V Inground’s cable directly to the driver or use suitable cable joint
box(water-proof for outdoor installation) if the cable has to be extended.
For the number of V Inground projectors that can be linked together , please follo w the Maximum power
output limit of each zone of the V Power.
The RJ45 plug that connects the V Inground unit to the V Power driver has the following wiring:
PIN Color of wire RGB
1 White/Orange Not used
2 Orange Red LED +
3 White/Green Blue LED +
4 Blue Green LED +
5 White/Blue Not used
6 Green Red LED 7 White/Brown Blue LED 8 Brown Green LED -
RJ45 plug
(View facing pins)
4.Change Beam Angle
In this V Inground series, if you want to change the beam angle of fixture, you can change lens of the fixture
refer to the photo below:
5. Maintenance
- Clean the front transparent cover at least every 1-2 months. Use a moist, lint-free cloth. Never use alcohol
or solvents!
Loading...