VISICAM TC 20 Installation Quick Manual

VWR_Quick_Guide_VisicamTC20_Feb15_rev0.docx

1 / 4

Tablet Camera VisiCam TC 20

ECN# 630-2589

INSTALLATION QUICK GUIDE

Box contains:

1 10’’ Tablet
1 CMOS Camera with WiFi module
1 Connection bifurcate cable (connects camera to wifi module)
1 Power supply (9Volt) for WiFi module, with plugs
1 Power supply (5Volt) for Tablet with USB cable, with plugs
1 Tiltable support for Tablet
1 User manual, 1 Quick guide

Remove all the parts from the package and check if any visible damage has occured

1. SWITCH-ON OF VISICAM TC20 TABLET CAMERA

Follow the instructions in the order as described below.

ATTENTION: before doing the connections, be sure that the Tablet is switched off

WiFi module

Camera

VWR_Quick_Guide_VisicamTC20_Feb15_rev0.docx

2 / 4

1. Connect the connection bifurcate cable to camera and to WiFi module

2. Connect the 9 Volt power supply to the WiFi module

3. Put the camera on your microscope trinocular port* or into one of the two eyepieces* (*a C-mount

adapter is necessary, not supplied)

4. Now connect the 9 Volt power supply of WiFi module to the electrical mains, you should see the

red led light on the camera back side switch on

5. Put the Tablet support on the table and put the Tablet on the support

6. Now switch on the Tablet

7. On the Tablet, go to Settings / Language and set your preferred language (factory setting is English)

8. On the Tablet, go to Settings / Wi-Fi / and you will find the network created by the Wi-fi module of

the camera, this is called “Wireless 11n AP-xxxxx” (where xxxxx is unique number for each VISICAM
TC20 system). No password is required to connect to this network.
If you do not find this network on the list of networks available, please check that the power supply
(9 Volt) of Wifi module if has been properly connected to the Wi-Fi module and that the
connections between camera and Wi-Fi module have been made correctly.
If connection to the network of the camera has been succesful, then exit the Settings menu and
return to the main window of the Tablet

9. Now you can touch the icon “Tabkam View” Application to start working

WiFi module

9Volt power

supply

Camera

Bifurcate
cable