Viper VN1715, VN2015 Owner's Manual

CONGRATULATIONS on your purchase of a Viper product

and welcome to the V.I.P. family. We appreciate your

business and will do everything in our power to keep you happy

with your purchase for many years to come.

As part of the V.I.P. family, you are entitled to the best

protection by one of the most comprehensive warranties in

the industry.

Thank-you for purchasing Viper products!

Tom Vander Bie, CEO

TABLE OF CONTENTS

Safety Precautions 3

Machine Operation 4

Machine Maintenance & Storage 4

Parts List 5 - 9

Wi

ring Diagra

10

SAFETY PRECAUTIONS

GROUNDING INSTRUCTIONS

General –This floor – finishing machine shall be
grounded while in use to protect the operator
from electric shock. The machine is provided
with a three –conductor cord and a three contact
grounding type attachment plug to fit the proper
grounding type receptacle. The green [or green
and yellow] conductor in the cord is the
grounding wire. Never connect this wire to other
than the grounding pin of the attachment plug.

This machine is for use on a nominal 120-Volt
circuit and has a grounding plug that resembles
the plug illustrated in fig ure below. Make sure
that the machine is connected to an outlet
having the same configuration as the plug. No
adapter should be used with this machine.

This machine is intended for Commercial use. It
is constructed for use in an indoor environment
and is not intended for any other use. Use only
recommended accessories.

All operators shall read, understand and
exercise the following safety precautions:

1] Do not operate machine:

- Unless trained and authorized.

- Unless you have read and understand

operators manual.

- In flammable or explosive areas.

- With a damaged cord or plug.

- If not in proper operating condition.

- In outdoor areas.

- In standing water.

- With the use of extension cords.

2] Before operating machine:

- Make sure all safety devices are in place
and operate properly.

3] When using machine:

- Do not run machine over cord.

- Do notpull machine by cord or plug.

- Do not pull cord around sharp edges of

corners.

- Do not unplug by pulling on the cord.

- Do not stretch cord.

- Do not handle plug with wet hands.

- Keep cord away from heated surfaces.

- Report machine damage of faulty

operation immediately.

4] Before leaving or servicing machine:

- Turn off machine.

- Unplug cord from outlet.

5] When servicing machine:

- Unplug cord from outlet.

- Use manufacturer supplied or approved

replacements parts.

-

3