Viper Home 502M, 502M Quick Reference Manual

502M Motion Detector

Quick Reference Guide

Congratulations on the purchase of your Viper
Home Security Accessory. This guide walks you
through the process of adding this accessory to your
system and for mounting your accessory.

Note: Make sure you already have a Viper Home
Starter kit or Viper Home Hub installed. Please refer
to the quick reference guides found in these sys­tems, or visit: www.viper.com/home/support.

1. Log into your Viper Home account at:

home.viper.com

2. To pair the motion detector to your system:

Click on the “Devices” tab
Click “Add New Device”
Click “Add Motion Detector”

3. You are then prompted to insert the batteries

provided within three
minutes. First, remove
the mounting piece/bat­tery cover on the back of
the motion detector, and
install the AA batteries
provided.

4. Once the batteries are

inserted the system
automatically connects

© 2013 Directed. All rights reserved.2

and confirms the motion detector is paired
with your system.

5. After the motion detector is paired, you can

give it a unique name (i.e. “Living Room”)
In this screen, if you click the “More” button,
you can set up additional options for the de­vice, such as “arm stay”, or “custom arm”, as
well as select what action the motion detector
performs when triggered.

6. Once completed, click the “Finish” button.

The motion detector is now ready for mount­ing.

Mounting instructions:

1. The spherical lens must be

pointing down and placed on a
wall where it will detect move­ment inside the room.

2. The device should be placed

approximately 86” from the
floor and at least 4” from the
ceiling.
Note: Do not place the device
in an area that receives direct
sunlight.

3. Once you have chosen the

desired mounting location,
remove the backing from the
tape on the battery cover and mount the de­vice. Alternatively, you can also mount the de­vice with standard drywall screws by screwing

Ceiling

Floor