Viper 503V Owner's Manual
503V Motion Sensor with Camera
Quick Reference Guide
Congratulations on the purchase of your Viper
Home Security Accessory. This guide walks you
through the process of adding this accessory to your
system and for mounting your accessory.
Note: Make sure you already have a Viper Home
Starter kit or Viper Home Hub installed. Please refer
to the quick reference guides found in these systems, or visit: www.viper.com/home/support.
1. Log into your Viper Home account at:
2. To pair the Camera to your system:
Click on the “Devices” tab
Click “Add New Device”
Click “Add Camera”
3. You are then prompted to insert the batteries
provided within three
minutes. First, remove
the mounting piece on
the back of the camera,
then remove the battery
cover and install the AA
batteries provided.
4. Once the batteries are
inserted the system
automatically connects
home.viper.com
and confirms the camera is paired with your
system.
5. After the camera is paired, you can give it a
unique name (i.e. “Living Room”)
In this screen, if you click the “More” button,
you can set up additional options for the device, such as “arm stay”, or “custom arm”, as
well as select what action the camera performs
when triggered.
6. Once completed, click the “Finish” button.
The camera is now ready for mounting.
Mounting instructions:
1. The spherical lens must be
pointing down and placed on a
wall where it will detect movement inside the room.
2. For best results, mount the
camera on a wall where it can
capture images as an intruder
enters the home.
3. The device should be placed
approximately 86” from the
floor and at least 4“ from the
ceiling.
Note: Do not place the device
in an area that receives direct
sunlight.
4. Once you have chosen the desired mounting
location, remove the backing from the tape
on the mounting piece and mount the device.
Ceiling
Floor
© 2013 Directed. All rights reserved.2
Loading...