Viking Range VUIM150DLSS Use & Installation Instructions Manual

USE/INSTALLATION
INSTRUCTIONS

15” W. UNDERCOUNTER/FREESTANDING
ICE MACHINE

RReettaaiinn ffoorr FFuuttuurree RReeffeerreennccee

VIKING RANGE CORPORATION

111 FRONT STREET

GREENWOOD, MISSISSIPPI 38930 USA

[phone]

IMPORTANT - PLEASE READ AND FOLLOW

••

Before beginning, please read these instructions completely and carefully.

• Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.

• Please observe all local and national codes and ordinances.

• Please ensure that this product is properly grounded.

• The installer should leave these instructions with the consumer who should retain them for local inspector’s use and
for future reference.

WARNING

::

TToo rreedduuccee tthhee rriisskk ooff ffiirree,, eelleeccttrriiccaall sshhoocckk,, oorr iinnjjuurryy wwhheenn uussiinngg yyoouurr uunnddeerrccoouunntteerr iiccee mmaacchhiinnee,, ffoollllooww bbaassiicc
pprreeccaauuttiioonnss iinncclluuddiinngg tthhee ffoolllloowwiinngg::

•FOR YOUR SAFETY•

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR
ANY OTHER APPLIANCE. THE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION.

IItt iiss yyoouurr rreessppoonnssiibbiilliittyy ttoo bbee ssuurree yyoouurr iiccee mmaacchhiinnee iiss::

•located so the front is not blocked to restrict incoming or discharge air flow.

•properly leveled.

•located in a well ventilated area.

•properly connected to a water supply and drain.

•connected to the proper kind of outlet, with the correct electrical supply and grounding. A 115 volt, 60 Hz, 15 amp

fused electrical supply is required.

NNOOTTEE::

Time delay fuse or circuit breaker is recommended.

•not used by anyone unable to operate it properly.

•used only for its intended purpose.

•properly maintained.

•SAVE THESE INSTRUCTIONS•

SSuuffffooccaattiioonn HHaazzaarrdd
RReemmoovvee ddoooorrss ffrroomm yyoouurr oolldd iiccee
mmaacchhiinnee..
FFaaiilluurree ttoo ddoo ssoo ccaann rreessuulltt iinn
cchhiilldd eennttr

raappmmeenntt,, wwhhiicchh ccaann

ccaauussee ddeeaatthh oorr bbrraaiinn ddaammaaggee..

IIMMPPOORRTTAANNTT::

Child entrapment and suffocation are not problems of the past.
Junked or abandoned refrigeration products are still dangerous, even if they will
sit for “just a few days.” If you are getting rid of your refrigeration product,
please follow the instructions below to help prevent accidents.

BBEEFFOORREE YYOOUU TTHHRROOWW AAWWAAYY YYOOUURR OOLLDD RREEFFRRIIGGEERRAATTIIOONN PPRROODDUUCCTT::

•Take off the doors.

•Leave the shelves in place so that children may not easily climb inside.

DANGER

PROPER DISPOSAL OF YOUR OLD REFRIGERATION PRODUCT

41006471

Rev. C

2

A

B

UNDERCOUNTER CABINET
CUTOUT

AA

15” (38.1 cm)*

BB

Min. 34 1/2” (87.6 cm)

Max. 35 1/8” (89.2 cm)

CC

24” (61.0 cm)

C

GENERAL INFORMATION

Unpack

1. Remove banding from bottom of carton. Lift carton up and off of the ice machine

2. Remove all tape and packaging material from the outside and inside of the cabinet.

3. Keep all carton packaging until your ice machine has been thoroughly inspected and found to be in good
condition.

Area Requirements

1. Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in
on the top and three sides, but the front

MMUUSSTT BBEE

unobstructed for air circulation and proper operation.

Installation should be such that the cabinet can be moved for servicing if necessary.

2. Unit should be in a well ventilated area. Best results are obtained at temperatures between 55

0

F (130C) and 800F

(27

0

C) for built-in indoor models, between 550F (130C) and 900F (320C) for indoor freestanding models, and between

45

0

F (7.20C) and 1100F (430C) for outdoor models.

3. Provisions for electricity should be determined before placing unit in proper place.

4. For best performance, outdoor units should be installed away from direct sunlight or under a counter or sink.

*15” (38.1 cm) width for cabinet only. If door
is recessed between cabinets, cabinet cutout
must be 15-1/4” (38.7 cm.).

3

SPECIFICATIONS/DIMENSIONS
PROFESSIONAL MODELS

BBaassiicc EElleeccttrriicc DDaattaa

•115 VAC/60 Hz

•Maximum amps - 3.0
Approximate Shipping Weight - 110 lbs.
(49.5 kg)

Front View

Side View

34 1/4”

(87.0 cm)

22” (55.9 cm)

27 1/8” (68.9 cm)

24 5/8” (62.6 cm)

37 9/16” (95.4 cm)

Min. 34 1/4”

(87.0 cm)

Max. 35”

(88.9cm)

26”

(66.0 cm)

14 3/4”

(37.5 cm)

4

SPECIFICATIONS/DIMENSIONS
DESIGNER MODEL

BBaassiicc EElleeccttrriicc DDaattaa

•115 VAC/60 Hz

•Maximum amps - 3.0

•Approximate Shipping Weight - 110 lbs. (49.5 kg)

Front View

Side View

34 1/4”

(87.1 cm)

22” (55.9 cm)

25 5/8” (65.1 cm)

24 5/8” (62.6 cm)

37 9/16” (95.4 cm)

Min. 34 1/4”

(87.0 cm)

Max. 35”

(88.9cm)

26”

(66.0 cm)

14 3/4”

(37.5 cm)

5

Screw
Impressions

leg leveler installation

READ BEFORE INSTALLING LEG LEVELERS

WARNING

Do not lay unit on top, side, back, or front. If unit is accidentally laid in any position other than right side up, then the
unit must remain in the right side up position for at least 24 hours before plugging the unit in.

1. Tip unit backwards so there is (1) foot of clearance on front of the unit. Have someone to assist you in tilting the
unit, to prevent it from falling on you while installing the leg levelers.

2. Screw front two leg levelers into the screw impressions. Leg levelers should be screwed in until snug.

3. Repeat steps 1 & 2, with the exception of tipping the unit forwards now, to screw in the back two leg levelers.

4. Your leg levelers are now installed.

5. The unit should be level from front to back and side to side. If floor conditions do not allow the unit to sit level,
adjust leg leveler(s) by turning the required leg leveler(s) counter-clockwise to increase their height and clockwise to
reduce their height.

6

WIRING DIAGRAM

UNDERCOUNTER 15” W. ICE MACHINE

WWAARRNNIINNGG:: EELLEECCTTRRIICCAALL
GGRROOUUNNDDIINNGG
IINNSSTTRRUUCCTTIIOONNSS

This appliance is equipped with a
three prong grounding plug for
your protection against shock
hazard and should be plugged
directly into a properly grounded
three prong receptacle. Do not
cut or remove the grounding
prong from this plug.

ELECTRICAL CONNECTION

EElleeccttrriiccaall RReeqquuiirreemmeennttss
A 115 volt, 60 Hz, AC only 15 amp fused electrical supply is required. (A time delay
fuse or circuit breaker is recommended.) It is recommended that a separate circuit,
serving only this appliance, be provided.

••EELLEECCTTRRIICCAALL GGRROOUUNNDD IISS RREEQQUUIIRREEDD OONN TTHHIISS AAPPPPLLIIAANNCCEE..

••DDOO NNOOTT UUNNDDEERR AANNYY CCIIRRC

CUUMMSSTTAANNCCEESS RREEMMOOVVEE TTHHEE PPOOWWEERR

SSUUPPPPLLYY CCOORRDD GGRROOUUNNDD PPLLUUGG..

••DDOO NNOOTT UUSSEE AANN EEXXTTEENNSSIIOONN CCOORRDD..

RReeccoommmmeennddeedd GGrroou

unnddiinngg MMeetthhooddss

For your personal safety, this refrigeration product must be grounded. This appliance is equipped with a 5’ power supply cord
having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong
grounding type wall receptacle grounded in accordance with the National Electrical Code and local codes and ordinances. If
the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the customer to exchange the
existing receptacle in accordance with the National Electrical Code and applicable local codes and ordinances. The third
ground plug SHOULD NOT, under any circumstances, be cut or removed. All UL listed refrigerated products are equipped
with this type of plug.

Power Supply

with 3-prong

grounding plug

Grounding type wall
receptacle

WARNING

ELECTRICAL SHOCK HAZARD

Failure to follow these instructions could result in fire or electrical shock.