Viking Range BRTGK72SS, PBRTGK72SS Installation Instructions Manual

VIKING RANGE CORPORATION

Please refer to Installation Instructions provided with bottom mount refrigerator/freezer for additional information.

Most of the refrigerator’s weight is at the top. Extra care is needed when moving the
refrigerator to prevent tipping.
Keep cardboard shipping piece or plywood under refrigerator until it is install

ed in

the operating position.

Your safety and the safety of others

is very important.

You will be killed or seriously injur

ed if you

don’t follow instructions.

You can be killed or seriously injured if
you don’t follow inst

ructions.

TIP OVER HAZARD
Refrigerator is top heavy and tips easily when
not completely installed.
Keep doors

closed until refrigerator is

completely installed and secured with lag bolts
to rear wall. Use two

or more people to move

and install refrigerator. Failure to do so can
result in death or serious i

njury

INSTALLATION

Greenwood, Mississippi 38930 USA

111 Front Street

[phone]

INSTRUCTIONS

BUILT-IN BOTTOM MOUNT REFRIGERATOR/FREEZER
BRTGK72SS/PBRTGK72SS GRILLE KITS
(FOR PROFESSIONAL SERIES ONLY)

IMPORTANT - PLEASE READ AND FOLLOW

Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage, frequency, wattage,
amperage, and phase is attached to the product.

To reduce the risk of fire, electric shock, or injury to persons, installation work and electrical wiring must be done by qualified
people in accordance with all applicable codes and standards, including fire-rated construction.

The installer should leave these instructions with the consumer who should retain for local inspector’s use and for future
reference.

GENERAL INFORMATION

We have provided many important safety
messages in this manual and on your
appliance. Always read and obey all
safety messages.
This is the safety alert symbol. This

symbol alerts you to hazards that
can kill or hurt you and others.

All safety messages will be
preceded by the safety alert symbol and
the word “DANGER” or “WARNING”.
These words mean:

All safety messages will identify the
hazard, tell you how to reduce the chance
if injury, and tell you what can happen if
the instructions are not followed.

r

e

It is your responsibility to :

-comply with installation specifications and dimensions

-properly install refrigerator

-remove any moldings or decorative panels that prevent the refrigerator from
being serviced

-make sure that you have these materials, (not provided with the unit), which
are necessary for proper installation:

2 - 1/4” (6 mm) copper tubing with shutoff valve
2 - 1/4” (6mm) compression fitting
#8 x 3” (7.6 cm) wood screws (Longer screws may be required.)

BRTGK72SS - Qty 12
PBRTGK72SS - Qty 12

2 - saddle valves (do not use self-piercing valves).

n

e

-assure that floor will support refrigerator, door panels and contents,
(approximately 1200 lbs. [540 kg.])

-provide a properly grounded electrical outlet

-assure that location will permit appliance doors to open 90

o

minimum

BASIC SPECIFICATIONS AND DIMENSIONS

DESCRIPTION BRTGK72SS PBRTGK72SS

(per unit)

VCBB363-DUAL INSTALLATION

Overall Width 72” (182.9 cm)

Overall Height from Bottom Min. 82 3/4” (210.2 cm)

Overall Depth from Rear To rear edge of side trim 22 3/16” (56.4 cm)

To front of top grille 24 11/16” (62.7 cm)
To end of handle bracket 27 1/4” (69.2 cm)

Cutout Width 71 1/2” (181.6 cm)

Cutout Height Min. 82 7/8” (210.3 cm)

Cutout Depth 24” (61.0 cm) min.

Electrical Requirements (2) - 115 volt, 60 Hz, 15 amp dedicated circuit; 3-wire cord with grounded 3-

prong plug attached to product.

Maximum Amp Usage 9.9 amps (per unit)

Inlet Water Requirements (2) - 1/4” copper tubing inlet waterline; minimum 20 psi; maximum 120 psi

Overall Interior Capacity

•Refrigerator 15.2 cu. ft. (.43 cu. meters)

•Freezer 5.1 cu. ft. (.14 cu. meters)

•Total Capacity 20.3 cu. ft. (.57 cu. meters)

Approximate Shipping Weight 575 lbs. (258.8 kg) - per unit

Max. 84 1/16” (213.5 cm)

Max. 84 1/16” (213.5 cm)

2

SITE PREPARATIONS AND CONSIDERATIONS

ELECTRICAL
RECEPTACLE
LOCATIONS
(SHADED AREAS)

1” (2.5 cm) TYP

FOUR (2 per unit)

82 7/8” (210.5 cm) Min.

anti-tip board and opening height

84 1/16” (213.5 cm) Max.

anti-tip board and opening height

71 1/2” (181.6 cm) FOR TWO

PROFESSIONAL STYLE 36” W.

BOTTOM MOUNT REFRIGERATORS

35 13/16” (91.5 cm)

39 3/16” (99.5 cm)

Water line
entry area

Water

line

Water
line

BRTGK72SS
PROFESSIONAL 36” W. BOTTOM MOUNT DUAL INSTALLATION,
CABINET OPENING DIMENSIONS

3

(2 per unit) 2” x 4” mounting boards (1-1/2” [3.8 cm] x 3-1/2” [8.9 cm])
NOTE: If unit is installe

d deeper than 24” (61.0 cm), then shim behind anit-tip bracket

thickness by the same amount.

29” (73.7 cm) 29” (73.7 cm)

3” (7.6 cm)

3-1/2”
(8.9 cm)

3-1/2”
(8.9 cm)

Bottom of anti-tip board is 3-7/8”
(9.8 cm) below opening height.
NOTE: Top of unit must be
firmly

seated under anti-tip

board.

6”

(15.2 cm)

6”

(15.2 cm)

9”
(22.2 cm)

Water line
entry area

82-7/8” (210.5 cm) min.
anti-tip board and opening height

84-1/16” (213.5 cm) max.
anti-tip board an

d opening height

73-3/8”

(186.4 cm)

SITE PREPARATIONS AND CONSIDERATIONS

71 1/2” (181.6 cm) FOR TWO

PROFESSIONAL STYLE 36” W.

BOTTOM MOUNT REFRIGERATORS

Water
Line

Water
Line

24” (61.0 cm)

PBRTGK72SS
PROFESSIONAL 36” W. BOTTOM MOUNT DUAL INSTALLATION,
CABINET OPENING DIMENSIONS

d

Electrical outlet
location

Electrical outlet
location

s

d

4