Viking VWH3010LSS, VWH3610LSS Installation

Installation Guide

Professional Built-in

Hoods

Table of Contents

2

Warnings & Important Information

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3

VWH 10”H. Wall Hoods w/Standard Ventilator 30”, & 36”

D i m e n s i o n s & S p e c i f i c a t i o n s _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5
Clearance Dimensions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6

Interior Ventilator Dimensions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7
Planning Information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8
Installation Procedures

Installation (VWH 10”H. Wall Hoods w/Standard Ventilator) _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9

Duct Cover Option (VWH 10”H. Wall Hoods w/Standard Ventilator)_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11

Installation (VWH 10”H. Wall Hoods w/Recirculating Kit) _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11
Service & Registration_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 1 5

3

IMPORTANT–Please Read and Follow!

NOTE:

If installing hood with warming shelf panel,

install warming shelf panel first.

IMPORTANT – PLEASE READ AND FOLLOW

• Before beginning, please read these instructions

completely and carefully.

• Do not remove permanently affixed labels,

warnings, or plates from the product. This may
void the warranty.

• Please observe all local and national codes and

ordinances. If no local codes are applicable, wire
in accordance with the National Electrical Code,
ANSI/NFPA 70-latest edition.

• Damp environment approved models should be

installed in a covered non-enclosed area and
should be protected from the elements as much
as possible.

• The installer should leave these instructions with

the consumer who should retain for local
inspector’s use and for future reference.

• Check with a qualified and trained installer or local

codes for makeup air requirement, if any.

This hood is for residential installation only and is
not designed for installation over a commercial
product. Make sure power is off at the main circuit
breaker or fuse box before making connections. To
avoid risk of fire, electric shock, or injury to persons,
turn off the electricity to the hood from the power
supply before servicing or cleaning. Our hoods are
equipped with variable speed control blowers.
These units will not function with a single speed
ventilator. All Viking Range ventilator kits are
designed specifically for use with Viking Range
hoods. Use of any non-Viking Range ventilator kit
will void the hood warranty.

READ AND SAVE THESE INSTRUCTIONS

TO REDUCE THE RISK OF FIRE, ELECTRICAL
SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:

1. Installation work and electrical wiring must
be done by qualified person(s) in
accordance with all applicable codes and
standards, including fire-rated construction.

2. Sufficient air is needed for proper
combustion and exhausting of gases
through the flute (chimney) of fuel burning
equipment to prevent back drafting. Follow
the heating equipment manufacturer’s
guideline and safety standards such as
those published by the National Fire
Protection Association (NFPA), and the
American Society for Heating, Refrigeration
and Air Conditioning Engineers (ASHRAE),
and the local code authorities.

3. When cutting of drilling into wall or ceiling,
do not damage electrical wiring and other
hidden utilities.

4. Ducted fans must always be vented to the
outdoors.

5. WARNING!: To reduce risk of fire, use only
metal ductwork

6. CAUTION!: To reduce risk of fire and to
properly exhaust air, be sure to duct air
outside. Do not vent exhaust air into
spaces within walls or ceilings, or into
attics, crawl spaces, or garages.

7. CAUTION!: To Reduce the Risk of Fire and
Electric Shock, Install this rangehood only
with remote blower models manufactured
by Viking, model numbers –
DEV900/DEV1200, VEV900/VIL1200, OR
integral blowers manufactured by Viking
Range, model numbers –
VINV300/600/1200, or DIL1200. NOTE –
Please refer inside for specific
canopy/blower combinations.

WARNING

IMPORTANT–Please Read and Follow!

4

WARNING

TO REDUCE THE RISK OF
FIRE, ELECTRICAL SHOCK, OR
INJURY
TO PERSONS

Rangehoods must be installed
with the ventilators that are
specified on their carton
indicating suitability with this model. Other
ventilators cannot be substituted.

CAUTION

For general ventilating use only. Do not use to
exhaust hazardous or explosive materials and
vapors.

WARNING

To reduce the risk of injury to persons in
the event of a rangetop grease fire,
observe the following. (Based on “Kitchen
Firesafety Tips,” published by NFPA.)

1. SMOTHER FLAMES with a close fitted lid,
cookie sheet, or metal tray, then turn off the
burner. BE CAREFUL TO PREVENT BURNS.
If the flames do not go out immediately,
EVACUATE AND CALL THE FIRE
DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN. You may
be burned.

3. DO NOT USE WATER, including wet
dishcloths or towels a violent steam
explosion will result.

4. Use an extinguisher ONLY if

• You know it is a Class ABC extinguisher,
and you already know how to operate it.

• The fire is small and contained in the area
where it started.

• The fire department is being called.

• You can fight the fire with your back to an
exit.

WARNING

To reduce the risk of fire, electric shock, or
injury to persons, observe the following:

• Use this unit only in the manner intended by
the manufacturer. If you have any questions,
contact the manufacturer.

• Before servicing or cleaning unit, switch
power off at service panel and lock service
panel to prevent power from being switched
on accidentally. When the service
disconnecting means cannot be locked,
securely fasten a prominent warning device,
such as a tag, to the service panel.

5

21”

(53.3 cm)

A

10 ”

(25.4 cm)

12 ”

(30.5 cm)

A (Hood width)
30”W. 29-7/8“ (76.2 cm)
36”W. 35-7/8” (91.1 cm)

3”

(7.6 cm)

Dimensions & Specifications

(VWH 10”H. Wall Hoods w/Standard Ventilator 30”, & 36”)

* Disregard when using recirculating kits. Blower is shipped with hood.

NOTE: Optional duct cover sold separately.

VWH 10”H. Wall Hoods w/Standard Ventilator

Description 30” 36”

Duct cover width

29-7/8” (75.9 cm) 35-7/8” (91.1 cm)

Duct cover depth

12” (30.5 cm)

Duct cover height

12” (30.5 cm)

Number of lights

2

Number of filters

2

Heat lamps

N/A

Interior duct size*

7” (17.8 cm)

Interior—Maximum amps

5.6

Interior

Ventilator

Standard

Models

“L”

Models

“M”

Models

CFM

460 390 300