Installation
MANUAL
5 SERIES
Insulated Jacket
VIJ530 1
VIJ5361
VIJ5421
VIJ5541
1
IMPORTANT: Before you build the frame, you must take into consideration the total weight of the liner, grill
and any nishing materials.
Refer to the cutout dimension table for the proper framing dimensions for the insulation jacket. Determine
the entry point for both the gas inlet and electrical connections. Make the 4” square holes for gas and
electrical connections (rear or bottom access) based on your requirements.
Note: that the electrical connections are located on the left side and the gas connections are located on the
right side.
A Carpenter’s “spirit level” should be used to assure that the framing is level, both front to back and side to
side. Note: Never under any circumstance should you install the transformer or run a quick disconnect hose
inbetween the grill and the inside of the insulating jacket.
Liner Installation
Position the liner into the frame. No part of the combustible enclosure can protrude above the top surface
or in front of the face surface of the liner. Shim the liner if necessary.
Grill Installation
Use the proper equipment to support the grill. Place the grill into the liner and engage it over the liner lip
across the back and sides. The liner is designed to support the grill without additional fasteners.
If desired any gap remainng between the liner and the combustible enclosure may be lled with a noncombustilble sealant or caulk.
2
Cutout Dimensions
Model A B C D E F
VIJ5301 36 5 26 ½ 4 ½ 3 11
VIJ5361 42 5 23 ¾ 4 ½ 3 11 5/8
VIJ5421 48 5 26 ½ 4 ½ 3 11 5/8
VIJ5541 60 5 26 ½ 4 ½ 3 11 5/8
5/8
A
B
C
4” square holes for gas and electrical
connections (rear or bottom access).
Make these holes in the frame based
on your requirements
D
E
F
WARNING
The regulator to be installed outside the insulating
jacket. It can be positioned anywhere in the gas
supply line between the grill and the shuto valve.
Gas tubing should never be installed within the
insulated jacket.
3