Installation
GUIDE
NKVGR Natural Conversion Kit
for 7 Series Ranges/Rangetops
Table of Contents
Warnings.......................................................................................................................... |
3 |
Kit Contents..................................................................................................................... |
3 |
Regulator Conversion...................................................................................................... |
4 |
Infrared Broiler Conversion.............................................................................................. |
5 |
Surface Burner Conversion.............................................................................................. |
6 |
Griddle Conversion ......................................................................................................... |
9 |
Oven Bake Burner Conversion ...................................................................................... |
10 |
Rating Label locations ................................................................................................... |
11 |
2
IMPORTANT - Please Read and Follow!
WARNING
FIRE/EXPLOSION HAZARD
If the information in this guide is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
WHAT TO DO IF YOU SMELL GAS:
•DO NOT try to light any appliance.
•DO NOT touch any electrical switch.
•DO NOT use any phone in your building. •Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency, or the gas supplier.
CAUTION
Be sure the electric power is turned off at the breaker box while the unit is being converted.
CAUTION
Before placing the appliance into operation, always check for gas leaks with a soapy water
solution or other acceptable method. DO NOT use an open flame to check for leaks.
Natural Orifice Conversion Kit Contents
Description |
Part Number |
Size |
Quantity |
Front Surface Burners |
In bag 050300-000 |
#44 (2.18mm) |
4 |
Rear Center/Right Rear Surface Burners |
In bag 050300-000 |
#51 (1.70 mm) |
3 |
Left Rear Surface Burner |
In bag 050300-000 |
.048” (1.22mm) |
1 |
Main Oven Burner |
050279-000 |
#39 |
1 |
Left Oven (48” only) / Griddle Burner |
050288-000 |
#50 |
2 |
Infrared Broiler Burner |
050287-000 |
#48 |
1 |
Front Surface Burner Venturi |
050576-000 |
|
4 |
Conversion label |
PF030377 |
|
1 |
NKVGR Conversion Instructions |
F21389 |
|
1 |
|
|
|
|
NOTE: Depending on the model being converted, some of the orifices may not be used.
3
Regulator Conversion
•Remove hex nut from top of regulator. •Unsnap plastic plunger from hex nut. •Reverse plunger and reinstall onto hex nut by pressing firmly.
NOTE: Plunger is marked “NAT” or “LP”. Converted fuel type will be shown on the lower portion of plunger.
•Reinstall hex nut onto regulator in configuration desired.
Natural
Orientation
NAT
LP
LP Orientation
Apply sideways finger pressure to remove pin from cap.
conversion
LP
NAT
conversion
LP
NAT
NOTE: VGR748 models have two regulators. Make sure both regulators are converted. To access second regulator, the island trim and small panel on the back must be removed
Second regulator located behind small |
panel on VGR748 Gas Ranges. |
4