Viking BQC1360SS, BQC5540SS, BQC5300SS, BQC5420SS, VGBQ13002_Cart Use & Installation Manual

F20094E EN (021012

Viking Range Corporation

111 Front Street

Greenwood, Mississippi 38930 USA

[phone]

For product information,

call 1-888-VIKING1 (845-4641)

or visit the Viking Web site at

vikingrange.com

Viking Use/Installation Guide

Outdoor Gas Grill VGBQ

100, 300, and 500 Series Carts

3

2

IMPORTANT: PLEASE READ AND FOLLOW

1

. Before beginning, please read these instructions completely and carefully.

2

. Do not remove permanently affixed labels, warnings, or plates from product.

BEFORE INSTALLING GRILL TO CART: Remove drip tray, grill grates, flavor grids, and warming racks from the grill.

To remove side shelves:

The side shelves on the cart can be removed if needed. This mustbe done before installing the grill on the cart.
With the shelf in the up position, remove the screws in the shelf support bracket. This will allow you to remove both
the brackets and the shelf.

To mount grill to cart:
Always wear gloves when handling the gas grill. Although the grill is deburred prior to shipment, some edges may

still be sharp enough to causeinjury during handling. With a minimum of two (2) people, place the grill in the cart with
about 3 to 4 inches hanging out the front making sure that the male fitting on the bottom of the grill is inside the cart.
Push the grill back until the front sides of the cart are flush with the back of the landing ledge on the grill.

Be careful: the grill unit is very heavy!

Attaching the grill to the cart

Once the grill has been mounted on
the cart, the back of the landing
ledge should be flush with the front
sides of the cart. The 5/8” (1.6 cm)
hole on the top front corners of the
cart should be aligned with the
receiving holes in the grill heat
shields. If your grill does not have
the receiving holes in the heat shield,
you will need to drill them out with a
9/64” (.14 cm) drill bit. With the grill
and cart mounted together, place the
drill bit in the 5/8 hole and center in
the 1/4”x3/8” slot. Drill through the
heat shield. Take the #10X3/4” (1.9
cm) sheet metal screws (A) supplied
with the cart and attach the cart sides
to the grill. After securing the grill to
the cart, snap the hole covers (B)
supplied with the cart into the 5/8”
(1.6 cm) holes in the cart corners.

5/8”(1.6 cm) dia. hole

(A) #10 x 3/4”(1.9 cm)

sheet metal screw

(B) 5/8”(1.6 cm) hole cover

Support
bracket
screws

Shelf
adjustment
screw

Supports

Front View

Leveling the Side Shelves

To level the side shelves, lift the shelf so that the
shelf adjustment screw is visible between the two
supports on the shelf brackets. Turn the screw
with a 3/32” (.2 cm) allen wrench counter clockwise
to raise the shelf and clockwise to lower the shelf.