Installation
Professional Built-In Electric Warming Drawers
(Indoor and Outdoor Models)
VEWD527 / CVEWD527 / VEWD530 / CVEWD530
VEWDO530 / CVEWDO530 / VEWDO536 / CVEWDO536
Table of Contents
Warnings & Important Safety Instructions _______________________________________________3
Dimensions _________________________________________________________________________4
Specifications _______________________________________________________________________5
Cutout Dimensions (VEWD/VEWDO)___________________________________________________6
Electrical Requirements ______________________________________________________________7
General Information__________________________________________________________________8
Installation (VEWD/VEWDO) __________________________________________________________9
Final Preparation ___________________________________________________________________10
Service & Registration_______________________________________________________________11
2
IMPORTANT– Read and Follow!
Your safety and the safety of others is
very important.
We have provided many important safety
messages in this manual and on your
appliance. Always read and obey all
safety messages.
This is the safety alert symbol. This
symbol alerts you to hazards that
can kill or hurt you and others.
All safety messages will be preceded by
the safety alert symbol and the word
“DANGER,” “WARNING” or “CAUTION.”
These words mean:
Hazards or unsafe practices
which WILL result in severe personal
injury or death
Hazards or unsafe practices
which COULD result in severe personal
injury or death
Hazards or unsafe practices which
COULD result in minor personal injury or
property damage.
All safety messages will identify the
hazard, tell you how to reduce the chance
of injury, and tell you what can happen if
the instructions are not followed.
• Before beginning, please read these
instructions completely and carefully.
• DO NOT remove permanently affixed
labels, warnings, or plates from product.
This may void the warranty.
• All local and national codes and ordinances
must be observed. Installation must
conform with local codes, or in the absence
of codes, the National Electrical Code,
ANSI/NFPA70 - latest edition.
• The installer must leave these instructions
with the consumer who should retain for
local inspector’s use and for future
reference.
In Canada: Installation must be in accordance
with the current CSA C22.1 Canadian
Electrical Codes Part 1 and/or local codes.
FIRE AND ELECTRICAL
SHOCK HAZARD
To reduce the risk of electric
shock and fire, DO NOT use a
flexible power-supply cord with
this appliance.
For outdoor installation, installer must
install a ground fault interrupt.
Make sure that incoming voltage is the
same as unit rating. An electric rating plate
specifying voltage, hertz, wattage, amps,
and phase is attached to the product.
Wiring the warming drawer with more
voltage than it is rated for may cause
severe damage to the thermostat,
element, and other components. Wiring
the warming drawer with less voltage than
it is rated for may cause significant
decrease in performance.
To reduce the risk of fire, electric shock, or
injury to persons, installation work and
electrical wiring must be done by qualified
people in accordance with all applicable
codes and standards, including fire-rated
conditions.
3