Service & Registration ______________________________________________________________________27
• Before beginning, please read these
instructions completely and carefully.
• DO NOT remove permanently affixed
labels, warnings, or plates from product.
This may void the warranty.
• All local and national codes and ordinances
must be observed. Installation must
conform with local codes or in the absence
of codes, the National Fuel Gas Code
ANSIZ223.1/NFPA-54 –latest edition.
• The installer must leave these instructions
with the consumer who should retain for
local inspector’s use and for future
reference.
In Canada: Installation must be in accordance
with the current CAN/CGA B149.1 & 2 Gas
Installation codes and/or local codes. Electrical
installation must be in accordance with the
current CSA C22.1 Canadian Electrical Codes
Part 1 and/or local codes.
Commonwealth of Massachusetts:
• Installations and repairs must be
performed by a qualified or licensed
contractor, plumber or gas fitter, qualified
or licensed by the state, province or region
where this appliance is being installed.
• Use only gas shut-off valves approved foruse within the state, province or region
where this appliance is being installed.
• A flexible gas connector, when used,
must not exceed 3’ (.9 m).
To minimize exposure to these substances,
always operate this unit according to the
instructions contained in this book and
provide good ventilation.
Your safety and the safety of others is
very important.
We have provided many important safety
messages in this manual and on your
appliance. Always read and obey all
safety messages.
This is the safety alert symbol. This
symbol alerts you to hazards that
can kill or hurt you and others.
All safety messages will be preceded by
the safety alert symbol and the word
“DANGER,” “WARNING” or “CAUTION.”
These words mean:
Hazards or unsafe practices
which WILL result in severe personal
injury or death.
Hazards or unsafe practices
which COULD result in severe personal
injury or death.
Hazards or unsafe practices which
COULD result in minor personal injury or
property damage.
All safety messages will identify the
hazard, tell you how to reduce the chance
of injury, and tell you what can happen if
the instructions are not followed.
California Proposition 65
Burning gas cooking fuel generates some byproducts that are on the list of substances
known to cause cancer or reproductive harm.
2
3
IMPORTANT–Read and Follow!
DANGER
DANGER
DANGER
DANGER
WARNING
WARNING
Fire/explosion hazard.
IF THE INFORMATION IN
THIS MANUAL IS NOT
FOLLOWED EXACTLY, A
FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE,
PERSONAL INJURY, OR DEATH.
• DO NOT store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
• WHAT TO DO IF YOU SMELL GAS:
–DO NOT try to light any appliance.
–DO NOT touch any electrical switch;
DO NOT use any phone in your
building.
–Immediately call your gas supplier from
a neighbor’s phone.
–Follow the gas supplier’s instructions.
–If you cannot reach your gas supplier,
call the fire department.
• Installation and service must be
performed by a qualified installer, service
agency, or the gas supplier.
Chemical hazard.
To avoid risk of property
damage and/or personal injury
or death; this appliance is not
too be used as a heating source.
• Benzene is a chemical which is part of
the gas supply to this cooking product,
which is consumed in the flames during
combustion. Exposure to a small
amount of benzene is possible if a gas
leak occurs. Formaldehyde and soot are
by-products of incomplete combustion.
• This appliance contains or produces
chemicals which can cause serious
injury or death and which are known to
the state of California to cause cancer,
birth defects or other reproductive harm.
To reduce the risk from substances in
the fuel or from fuel combustion make
sure this appliance is installed,
operated, and maintained in accordance
to the instructions in this document.
Moving hazard.
To avoid risk of severe
personal injury; this appliance
requires two or more personnel
while handling and moving. Possible
use of appliance moving devices is
recommended.
Tipping hazard.
To reduce the risk of property
damage or personal injury;
install anti-tipping device
provided in accordance with
the installation instructions in
this document. Device must be
engaged properly to prevent
product from tipping over.
• This range can tip.
• Injuries to persons can result.
• Install anti-tip device packed with range.
• See installation instructions.
Gas leak hazard.
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer’s
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
properly grounded in accordance with
local codes or in absence of codes, with
the National Electrical Code (NEC).
ANSI/NFPA 70-latest edition.
Electrical shock hazard.
To avoid risk of electrical shock,
personal injury or death; verify
your appliance has been
4
5
Dimensions
3
5
-
7
/
8
”
(
9
1
.
1
c
m
)
m
i
n
.
t
o
3
7
”
(
9
4
.
0
c
m
)
m
a
x
.
1
”
(
2
.
5
c
m
)
2
9
-
7
/
8
”
(
7
5
.
9
c
m
)
3
5
-
7
/
8
”
(
9
1
.
1
c
m
)
4
7
-
7
/
8
”
(
1
2
1
.
6
c
m
)
6
0
”
(
1
5
2
.
4
c
m
)
25-3/4” (65.4 cm)
45-1/8” (114.6 cm)
19-3/8”
(49.2 cm)
8-1/8”
(20.6 cm)
26-7/16” (67.2 cm)
1-5/8”
(4.1 cm)
1” (2.5 cm)
35-7/8”
(91.1 cm) min.
to
37”
(94.0 cm) max.
24-5/16” (61.8 cm)
28-1/16” (71.2 cm)
Dimensions
Dual Fuel 30”, 36”, 48” and 60” W. Ranges
Dual Fuel 30”, 36”, 48” and 60” W. Ranges
Note: Unit shown with standard island trim.
Note: Unit shown with standard island trim.
*A 3/4” (1.9 cm) standoff is included on each 48” and 60”W. VDSC model range and is
required for installation against a combustible wall. These standoffs can easily be removed if
installing against a non-combustible wall. (See instructions on page 24.)
6
7
Specifications
Specifications
Dual Fuel 30” and 36” W. Ranges
Description
Overall width29-7/8”
Overall heightTo top of side trim - 35-7/8” (91.1 cm) min. 37” (94.0 cm) max.
Overall depth
from rear
Additions to Base
Height
Gas RequirementsShipped Natural or LP/Propane, field convert with conversion kit (purchased separately);
Gas Manifold PressureNatural 5.0” W.C.P./ Liquid Propane L/P 10.0” W.C.P.