Viking VCCI3610SB, VCCI4210VC, VCCI5410VC, VCCI6610VC Installation Manual

F1656B EN

(031308J)

Viking Installation Guide

Built-In Rangehood Accessories

Viking Range Corporation

111 Front Street

Greenwood, Mississippi 38930 USA

[phone]

For product information,

call 1-888-VIKING1 (845-4641)

or visit the Viking Web site at

vikingrange.com

BACKSPLASH

The backsplash is used to cover the wall space
between the top of the backguard or high shelf
and the bottom of the hood.

Place the backsplash in the desired location.
Secure to the wall by placing the screws that are
provided in the holes on the backsplash. When
screws are used to fasten the panel to materials
other than wood, the appropriate type anchor
should be used with the screws.

Backsplash

Screw
holes

WARMING SHELF PANEL

Always install the warming shelf panel
before installing the rangehood.

The warming shelf panel is usually
placed on the wall just below the
rangehood.

1. Place the bottom of the warming
shelf panel in the desired location
and secure to the wall.

2. Hook the bottom of the top
section to the top of the bottom
section and secure to the wall.

3. Install the rangehood so that it will
rest on the top ledge of the
warming shelf panel.

BOTTOM

TOP

Hook top section
to bottom section

Hood should rest on this top ledge

HOOD DUCT COVER

1. Mount duct cover to the ceiling through the screw holes provided. Secure to solid ceiling joists
to support the weight with the screws provided.

2. For wall hood models, after mounting the duct cover to the ceiling, attach the hood to the wall
and then secure the hood to duct cover using the sheet metal screws provided.

3. For island hood models, after mounting the duct cover to the ceiling, secure the hood by
tightening the bolts into the cage-nuts of the duct cover.

WALL RANGEHOOD DUCT COVER ISLAND RANGEHOOD DUCT COVER

Larger holes on

top

Smaller holes
on bottom

sheet metal screws

bolts

Cage nuts
on bottom

2 3