Viking VBI7360WLPG, VBI7360WRKA, VBI7360WLKA, VBI7360WRFW, VBI7360WLFW Installation Manual

...

Installation

Guide

Integrated Refrigerator / Freezer

7 SERIES

VBI7360 / CVBI7360

FBI7360 / CFBI7360

MVBI7360 / CMVBI7360

MFBI7360 / CMFBI7360

Table of Contents

Warnings and Important Information _______________________________________________________ 3

Professional Bottom-Freezer

Dimensions _______________________________________________________________________ 5

Speci cations ______________________________________________________________________ 6

Cutout Dimensions__________________________________________________________________ 7

Anti-Tip Dimensions (36”) ____________________________________________________________ 9

General Information

Electrical Requirements _____________________________________________________________ 10

Water Requirements ________________________________________________________________ 11

Unpacking & Moving ___________________________________________________________________ 12

Installation

Door/Drawer Panel Adjustments ______________________________________________________ 12

Custom Front Panel Dimensions ______________________________________________________ 13

Custom Front Panel Install ___________________________________________________________ 14

Water Line Installation ______________________________________________________________ 15

Leveling Unit ______________________________________________________________________ 17

Kickplate Installation _______________________________________________________________ 17

Flush Mount Side Trim ______________________________________________________________ 18

Door Stop Adjustment ______________________________________________________________ 19

System Speci cations and Data _______________________________________________________ 21

Performance Checklist __________________________________________________________________ 21

Control Panels _________________________________________________________________________ 21

Service & Registration __________________________________________________________________ 22

IMPORTANT – Please Read and Follow!

• Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage, frequency, wattage, amperage, and phase is attached to the product.

• To reduce the risk of  re, electrical shock, or injury to persons, installation work and electrical wiring must be done by a quali ed technician in accordance with all applicable codes and standards, including  re-rated construction.

• The installer should leave these instructions with the consumer who should retain them for local inspector’s use and for future reference.

For additional information or installation videos, visit our website at www. vikingrange.com

Your safety and the safety of others is very important.

We have provided many important safety messages in this manual and on your appliance. ALWAYS read and obey all safety messages.

This is the safety alert symbol. This symbol alerts you to hazards that can kill or hurt you and others.

All safety messages will be preceded by the safety alert symbol and the word “DANGER” or “WARNING.” These words mean:

DANGER

You will be killed or seriously injured if you

don't follow instructions.

WARNING

You can be killed or seriously injured if you

don't follow instructions.

All safety messages will identify the

hazard, tell you how to reduce the chance

of injury, and tell you what can happen if

the instructions are not followed.

It is your responsibility to:

• comply with installation speci cations and dimensions.

• properly install unit.

• remove any moldings or decorative panels that prevent the unit from being serviced.

• make sure that you have these materials (not provided with your unit), which are necessary

for proper installation:

• 1/4” (6 mm) copper tubing with shuto valve

• 1– Saddle valve (do not use self-piercing feature of the valve)

• assure that  oor will support unit, door panels and contents (approximately

1200 pounds [540 kg]).

• provide a properly grounded electrical outlet.

• assure that location will permit appliance doors to open 90º minimum.

Required tools

• Drill

• Drill bits - 3" Phillips (Ph2), Torx (T15 & T20), 1/4" and 5/16" hex drive

• Rubber mallet

• 3/8" wrench

IMPORTANT – Please Read and Follow!

A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local laws, or local

ordinances.

• The required use of a GFI is normally related to the location of a receptacle with respect to any signi cant sources of water or moisture.

• Viking Range, LLC will installed properly or do not meet the requirements below.

If the use of a GFI is required, it should be:

• Of the receptacle type (breaker type or portable type

• Used with permanent wiring only (temporary or portable wiring

• On a dedicated circuit (no other receptacles, switches or loads in the circuit)

• Connected to a standard breaker of appropriate size (GFI breaker of the same size recommended)

• Rated for Class A (5 mA +/- 1 mA trip current) as per UL 943 standard)

• In good condition and free from any loose- tting gaskets (if applicable in outdoor situations)

• Protected from moisture (water, steam, high humidity) as much as reasonably possible

NOT warranty any problems resulting from GFI outlets which are not

NOT recommended)

NOT

WARNING

ELECTRICAL SHOCK HAZARD Disconnect power or turn power disconnect switch to

OFF position before removing top grille. Failure to do so can result in death or electrical shock.

Power On/O Switch

Your unit is shipped with the power switch on. When  rst plugged in, the display will  ash. Push any button to initiate display.

The power on/o switch is located to the left of the center behind the access panel. It is used to turn the power o when cleaning or servicing the refrigerator.

To turn power o , remove the access panel. Press the power on/o switch to the o position.

To turn power on, press power on/o switch to the on position. Replace access panel.

and secured per installation instructions.

Use two or more people to move and install appliance. Failure to do so can result in death or serious injury.

WARNING

TIP OVER HAZARD Appliance is top heavy and tips easily when not completely installed. Keep doors closed until appliance is completely installed

access panel

Dimensions (Integrated Bottom-Freezer)

83-15/16”

(213.2 cm)

36”

(91.4 cm)

50-1/2”

(128.3 cm)

22-1/2”

(57.2 cm)

Model Dimension A Dimension B*

VBI7360/CVBI7360

FBI7360/CFBI7360

MVBI7360/CMVBI7360

12-1/8”

(30.8 cm)

17-1/16”

(43.3 cm)

4-1/16” (10.3 cm)

27-3/8" (69.5 cm) 24-3/4" (62.9 cm)

N/A 24" (61.0 cm)

27" (68.5 cm) 24-3/4" (62.9 cm)

*To outside of door panel

Speci cations (Integrated Bottom-Freezer)

36” Integrated Refrigerator/Freezer

Description VBI7360 / CVBI7360 MVBI7360 / CMVBI7360

Overall width 36" (91.4 cm)

Overall height (from bottom) 83-15/16" (213.2 cm) min to 84-3/4" (215.7 cm) max

Overall depth from rear To front edge kickplate: 22-1/2” (57.2 cm)

To front of door panel: 24-3/4” (62.9 cm)

To front of handle endcap:

27-3/8" (69.5 cm)

Cutout width 36" (91.4 cm)

Cutout height 84" (213.4 cm) min to 85-3/16" (216.3 cm) max

Cutout depth 25” (63.5 cm) min.

Electrical requirements 115 volt, 60 Hz, 15 amp dedicated circuit; 3-wire cord with

grounded 3-prong plug attached to product

Maximum amp usage 9.9 amps

Inlet water requirements 1/4” copper tubing inlet waterline; minimum 20 psi;

maximum 120 psi

Overall interior dimensions Refrigerator Freezer Total capacity

Approximate shipping weight 565 lbs. (254.3 kg)

13.6 cu. ft. (385.8 liters)

6.35 cu. ft. (180.1 liters)

19.95 cu. ft. (565.9 liters)

To front of handle endcap:

27" (68.5 cm)

36” Integrated Refrigerator/Freezer w/Custom Panels

Description FBI7360 / CFBI7360

Overall width 36" (91.4 cm)

Overall height (from bottom) 83-15/16" (213.2 cm) min to 84-3/4" (215.7 cm) max

Overall depth from rear To front edge kickplate: 22-1/2” (57.2 cm)

To front of door panel: 24” (61.0 cm)

Cutout width 36" (91.4 cm)

Cutout height 84" (213.4 cm) min to 85-3/16" (216.3 cm) max

Cutout depth 25” (63.5 cm) min.

Electrical requirements 115 volt, 60 Hz, 15 amp dedicated circuit; 3-wire cord with

grounded 3-prong plug attached to product

Maximum amp usage 9.9 amps

Inlet water requirements 1/4” copper tubing inlet waterline; minimum 20 psi;

maximum 120 psi

Overall interior dimensions Refrigerator Freezer Total capacity

Approximate shipping weight 565 lbs. (254.3 kg)

13.6 cu. ft. (385.8 liters)

6.35 cu. ft. (180.1 liters)

19.95 cu. ft. (565.9 liters)

Cutout Dimensions (Bottom-Freezer)

25”

(63.5 cm)

(213.4 cm) min.

opening height

85-3/16”

(216.3cm) max.

opening height

84”

Can be located on either side

Electric Outlet Location

15-1/2”

(39.4 cm)

4-1/4”

(10.8 cm)

leveling

dimension

Water Line Entry Area

36”

(91.5 cm)

36”

(91.5 cm)

*Note: For all models, 3” back from the front of the cabinet on both sides needs to  nished like the outside of the cabinets

5/8”

(1.6 cm)

1/2”

(1.3 cm)

6”

(15.2 cm)

3”

(7.6 cm)

Tipping Radius

9-1/2"

(24.1 cm)

(94.6 cm)

105

90

37-1/4"

39-5/16"

(99.8 cm)

36" (94.4 cm)

127-3/16" (323.1 cm)

91-7/16"

(232.3 cm)

87-3/4"

(222.9 cm)

111-3/16" (323.1 cm)

83-15/16"

(213.2 cm)

24-5/8"

(62.5 cm)

83-15/16"

(213.2 cm)

17-1/4"

(43.8 cm)

+ 16 hidden pages