Viking VBA Installation Manual

=

"

Center

=

"

Center

line to hole 12-13/16" (324.63 mm)

line to cutout 13-7/16" (341.6 mm)

=" Cutout Opening Width 26-15/16" (683.2 mm)

CABINET CUTOUT LINE

The exhaust duct should be aligned left to right with the left and right edges of the
bottom spacer. The front edge of the exhaust duct should be recessed from the edge of
the bottom spacer by 5 mm in order for the unit to be flush with the front surface of the
trim kit. The exhaust duct should be secured to the bottom spacer with Screw (C).

5/16" (8.77 mm)

BUILT-IN TRIM KIT

FLUSH MOUNTING TEMPLATE

FOR CUSTOM SERIES MICROWAVE OVEN

1. Align the Flush Mounting Template center line with the center of the cabinet. Align
the Floor Line with the bottom of the cabinet at the desired height. Tape it in place.

2. Cut the cabinet opening along the three Cabinet Cutout Lines and the Floor Line.

3. Install two Side Spacers (see FIGURE 1) and two Bottom Spacers (see FIGURE 2) as
specified in FIGURE 4.

4. Cut out the Side Spacer Templates (R and L) and align the indicated edge to the
corresponding Side Spacer (see FIGURE 3). Be careful to align the Floor Line to the
bottom edges of the Side Spacers.

4"

12-1/8" (308.45 mm)

22-1/16" (561.0 mm)

4"

1-15/16" (50.35 mm)

24-5/8" (625.5 mm)

5/16" (8.77 mm)

(2) Bottom Spacer

14-1/4" (361.8 mm)

A

TOP VIEW

(1) Bottom Spacer

1-15/16" (49.9 mm)

5. Predrill two holes indicated “A“ in Side Spacer - R with a /" drill bit.

6. Predrill two holes indicated ”B“ in Side Spacer - L with a /" drill bit.

7. Remove template from the cabinet.

(2) bottom spacers

24-5/8" width

CENTER LINE

FIGURE 3

Front of Cabinet

Cutout Opening Height 19-7/8" (504 mm)

Height Distance Between Holes

Edges to align Side Spacer Templates (R and L)

1"

(25.4 mm)

FIGURE 1

Side Spacer (2 required)
Must protrude from edge of cabinet
cutout towards center as shown.

FIGURE 2

Bottom Spacers (2 required).

1-9/16" height

Side Spacer -

FIGURE 4

L

Side Spacer -

R

CABINET CUTOUT LINE

Bottom Spacers centered with cabinet cutout

TINSKB140MRR0

VBA

@" Centerline to hole 14-5/16" (362.73 mm)

@" Centerline to cutout 14-15/16" (379.71 mm)

@" Cutout Opening Width 29-15/16" (759.42 mm)

FLOOR LINE OF CUTOUT OPENING

2-13/16"

(71.1 mm)