Viking UB4 Installation Manual

Center

line to hole 12-13/16" (324.63 mm)

line to cutout 13-7/16" (341.6 mm)

=" Cutout Opening Width 26-15/16" (683.2 mm)

CABINET CUTOUT LINE

The exhaust duct should be aligned with the front of the bottom spacer closest to the cabinet opening. The exhaust duct should align left to right with the left and right edges of the bottom spacers. The exhaust duct should be secured to the bottom spacer

5/16" (8.77 mm)

BUILT-IN TRIM KIT

FLUSH MOUNTING TEMPLATE

FOR CUSTOM SERIES MICROWAVE OVEN

1. Align the Flush Mounting Template center line with the center of the cabinet. Align the Floor Line with the bottom of the cabinet at the desired height. Tape it in place.

2. Cut the cabinet opening along the three Cabinet Cutout Lines and the Floor Line.

3. Install two Side Spacers (see FIGURE 1) and two Bottom Spacers (see FIGURE 2) as specified in FIGURE 4.

with Screw (C).

24-5/8" (625.5 mm)

(2) Bottom Spacer

5/16" (8.77 mm)

15-3/4" (399.63 mm)

TOP VIEW

12-1/8" (308.45 mm)

22-1/16" (561.0 mm)

4. Cut out the Side Spacer Templates (R and L) and align the indicated edge to the corresponding Side Spacer (see FIGURE 3). Be careful to align the Floor Line to the bottom edges of the Side Spacers.

5. Predrill two holes indicated “A“ in Side Spacer - R with a /" drill bit.

6. Predrill two holes indicated ”B“ in Side Spacer - L with a /" drill bit.

7. Remove template from the cabinet.

CENTER LINE

1-15/16" (50.35 mm)

FIGURE 3

Front of Cabinet

(1) Bottom Spacer

1-15/16" (49.9 mm)

Cutout Opening Height 21-5/16" (542 mm)

Height Distance Between Holes

Edges to align Side Spacer Templates (R and L)

(25.4 mm)

FIGURE 1

Side Spacer (2 required) Must protrude from edge of cabinet cutout towards center as shown.

(2) bottom spacers

24-5/8" width

FIGURE 2

Bottom Spacers (2 required).

1-5/8" height

Side Spacer -

CABINET CUTOUT LINE

TINSKB145MRR0

@" Centerline to hole 14-5/16" (362.73 mm)

@" Centerline to cutout 14-15/16" (379.71 mm)

@" Cutout Opening Width 29-15/16" (759.42 mm)

FIGURE 4

Bottom Spacers centered with cabinet cutout

FLOOR LINE OF CUTOUT OPENING

2-13/16"

(71.1 mm)

UB4