Viking TVWH360, CTVWH360, TVWH480, CTVWH480, TVWH660 Installation Guide

Installation

Tuscany Hoods

TVWH360, CTVWH360
TVWH480, CTVWH480
TVWH660, CTVWH660

NOTE:

If installing hood with warming shelf panel, install warming shelf panel first.

IMPORTANT – PLEASE READ AND FOLLOW

• Before beginning, please read these instructions completely and carefully.

• Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.

• Please observe all local and national codes and ordinances. If no local codes are applicable, wire in accordance with the
National Electrical Code, ANSI/NFPA 70-latest edition.

• Damp environment approved models should be installed in a covered non-enclosed area and should be protected from the
elements as much as possible.

• The installer should leave these instructions with the consumer who should retain for local inspector’s use and for future
reference.

• Check with a qualified and trained installer or local codes for makeup air requirement, if any.

This hood is for residential installation only and is not designed for installation over a commercial product. Make sure power is
off at the main circuit breaker or fuse box before making connections. To avoid risk of fire, electric shock, or injury to persons,
turn off the electricity to the hood from the power supply before servicing or cleaning. Our hoods are equipped with variable
speed control blowers. These units will not function with a single speed ventilator. All Viking Range ventilator kits are designed
specifically for use with Viking Range hoods. Use of any non-Viking Range ventilator kit will void the hood warranty.

READ AND SAVE THESE INSTRUCTIONS

2

Important Information

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2
W a r n i n g s _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3
D i m e n s i o n s & S p e c i f i c a t i o n s _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4
Clearance Dimensions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5
Interior Ventilator Dimensions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6
Exterior Ventilator Dimensions _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7
Planning Information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8
I n s t a l l a t i o n _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9
D u c t C o v e r O p t i o n _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 1 0
Service & Registration_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 1 1

Table of Contents

IMPORTANT–

Please Read and Follow!

3

TO REDUCE THE RISK OF FIRE, ELECTRICAL
SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:

1. Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-rated construction.

2. Sufficient air is needed for proper combustion
and exhausting of gases through the flute
(chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment
manufacturer’s guideline and safety standards
such as those published by the National Fire
Protection Association (NFPA), and the
American Society for Heating, Refrigeration and
Air Conditioning Engineers (ASHRAE), and the
local code authorities.

3. When cutting of drilling into wall or ceiling, do
not damage electrical wiring and other hidden
utilities.

4. Ducted fans must always be vented to the outdoors.

5. WARNING!: To reduce risk of fire, use only
metal ductwork

6. CAUTION!: To reduce risk of fire and to
properly exhaust air, be sure to duct air outside.
Do not vent exhaust air into spaces within walls
or ceilings, or into attics, crawl spaces, or
garages.

7. CAUTION!: To Reduce the Risk of Fire and
Electric Shock, Install this rangehood only with
remote blower models manufactured by Viking
Range, model numbers – DEV900/DEV1200,
VEV900/VIL1200 or integral blowers
manufactured by Viking,Range model numbers
– VINV300/600/1200 or DIl1200. NOTE –
Please refer inside for specific canopy/blower
combinations.

WARNING

WARNING

To reduce the risk of fire, electric shock, or injury to
persons, observe the following:

• Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact
the manufacturer.

• Before servicing or cleaning unit, switch power off
at service panel and lock service panel to prevent
power from being switched on accidentally. When
the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such
as a tag, to the service panel.

WARNING

TO REDUCE THE RISK OF FIRE,
ELECTRICAL SHOCK, OR INJURY
TO PERSONS

Rangehoods must be installed with
the ventilators that are specified on
their carton indicating suitability with
this model. Other ventilators cannot be substituted.

CAUTION

For general ventilating use only. Do not use to
exhaust hazardous or explosive materials and
vapors.

WARNING

To reduce the risk of injury to persons in the event
of a rangetop grease fire, observe the following.
(Based on “Kitchen Firesafety Tips,” published by
NFPA.)

1. SMOTHER FLAMES with a close fitted lid, cookie
sheet, or metal tray, then turn off the burner. BE
CAREFUL TO PREVENT BURNS. If the flames do
not go out immediately, EVACUATE AND CALL
THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN. You may be
burned.

3. DO NOT USE WATER, including wet dishcloths or
towels a violent steam explosion will result.

4. Use an extinguisher ONLY if

• You know it is a Class ABC extinguisher, and you

already know how to operate it.

• The fire is small and contained in the area where

it started.

• The fire department is being called.

• You can fight the fire with your back to an exit.

Warnings

CAUTION

This appliance is not to be used by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning the use of
the appliance by a person responsible for their
safety. Children should be supervised to ensure
that they do not play with the appliance.

24"

(61.0 cm)

A

18"

(45.7 cm)

12"*

(30.5 cm)

6"

(15.2 cm)

A
36" W 35-7/8" (91.1 cm)
48" W 47-7/8" (121.6 cm)

** It is recommended that the 1,500 CFM ventilator be used with longer duct runs. Max duct run is 75 ft.

NOTE: Maximum amp rating for hoods includes recommended ventilator kit rating; All products must be hard wired with 2­wire with ground. An interior- or exterior-power ventilator kit must be purchased for installation with all 18”H. hoods.

*NOTE: Optional duct cover sold separately.

18”H. Wall Hoods

Description 36” 48” 66”

Duct cover width

35-7/8”

(91.1 cm)

47-7/8”

(121.6 cm)

65-7/8”

(167.3 cm)

Duct cover depth

12” (30.5 cm)

Duct cover height

12” (30.5 cm)

Number of lights

2 3 3

Number of filters

2 3 3

Heat lamps

1 2 2

Interior ventilator kits

VINV300/
600/1200

VINV1200 VINV1200

Exterior ventilator kits

DEV900/

1200*

DEV1200*/

1500**

DEV1200*/

1500**

In-line ventilator kits

DIL1200 DIL1200 DIL1200

Interior duct size

7”/10”

(17.8/25.4 cm)

10”

(25.4 cm)

10”

(25.4 cm)

Exterior duct size

10” (24.5 cm)

Interior—Maximum amps

4.2/5.2/8.2 10.8 10.8

Exterior—Maximum amps

8.0/5.3 7.8/8.5 7.8/8.5

In-Line—Maximum amps

5.3/7.2 9.6 9.6

4

Dimensions & Specifications