Viking RDHK24 Installation Manual

F21024 EN

(082012)

RDHK24 D3 Handle Kit

For Use With FDB Dishwashers

Installation

Viking Range Corporation

111 Front Street

Greenwood, Mississippi 38930 USA

[phone]

For product information, call 1-888-VIKING1 (845-4641)

or visit the Viking Website at vikingrange.com

4

FDB - DISHWASHER

CUSTOM FRONT DIMENSIONS

Handle Installation

Section A-A

IMPORTANT–Please Read and Follow!

2

• Before beginning, please read these instructions completely and carefully.

• Use caution during assembly to minimize scratches.

• Do not remove permanently affixed labels, warnings or plates from the product. This may

void the warranty.

• Please refer to the product Installation Instructions for more information on
installing the door panel.

• The installer should leave instructions with the customer who should retain for local
inspector’s use and future reference.

Parts Included

Required Tools

To Install:

Installation with Wooden Full Overlay
Custom Door Front

1. Locate the wooden custom panel.

2. Using the illustrations on the next page, layout the handle location on the panels. It is
recommended that masking tape be placed where the four holes will be drilled to help mark
the hole placement and to prevent any damage to the door when drilling the holes.

3. The D3 handle will be mounted using (4) of the #10 x 3/4” Hex head screws provided. Using
the 3/16”(0.5 cm) drill bit, drill completely through the door in the hole locations. Using the
7/16” (1.1 cm) bit, counter-bore four holes 1/2” (1.2 cm) deep max. on the BACKSIDE of the
custom door panel.

4. Attach the D3 handle to the panel using (4) #10 x 3/4” screws provided.

Part Quantity

D3 Handles
End Caps
#10 x 3/4” Hex Head Screws
Installation Instructions

(1)
(2)
(4)
(1)

Electric Drill
3/16” (0.5 cm) Drill Bit
7/16” (1.1 cm) Spade or Forstner Bit (Counterbore)
Tape Measure
Hex Head Screw Driver
Masking Tape and Pencil